Emergency Board up >> Water Damage

In the case of a severe storm like a tornado or hurricane, the relentless pounding of the wind can cause Water Damage sometimes allowing the water to come in, through either a broken window, a splintered door or maybe some roof damage. Being proactive and planning ahead by the use of installing plywood over your windows and doors will usually pay huge dividends after the storm has died down and the winds have subsided.

  1. When attaching the plywood to the side of your house, the lag bolts should penetrate the wall and the frame surrounding the window at least 1-3/4 inches. For your larger windows, use 3/8-inch lag bolts that will penetrate the wall and frame surrounding the window at least 2-1/2 inches. For your Water Damage windows 3 — 4 feet or smaller that are installed on a masonry house, use 1/4-inch expansion bolts and galvanized permanent type expansion anchors. The expansion bolt shall penetrate the wall at least 1-1/2 inches. For your larger windows, use 3/8-inch expansion bolts that will penetrate the wall at least 1-1/2 inches.
  2. The tools that you will need are a circular or hand saw, a cordless drill with the appropriately sized bits, a claw hammer, and a wrench to fit the bolts. To be safe, always use eye protection and work gloves. Cut the Water Damage plywood for the measurements for each opening. Drill holes 2-1/2 inches from the outside of each edge of the plywood and at each corner and at 12-inch intervals. Drill four bolt holes in the center area of the plywood to relieve the pressure during a strong Water Damage storm. Place the plywood completely over the opening, and mark where each hole position on the outside wall. Drill the holes with the appropriate size and type of drill bit for the anchors. Install the anchors, the plywood, and the expansion bolts to make sure they will fit properly.
  3. On wood-frame houses, make sure that your anchors are secured into the solid pieces of wood that frames the door or window and not into the siding or trim alone. Mark each shutter so that you will know where it is to be installed, and store your shutters and the bolts in an easily accessible place. If the opening is larger than one sheet of plywood, you will also need to make shutters with a 2 — 4 bracing. This Water Damage bracing can be two 2 — 4s at the middle and bottom of the two sheets of exterior plywood, evenly spaced, with the 2-inch side also attached to the inside of your storm shutter.
  4. Attach the 2 — 4s to the outside of your storm shutter with 2-inch, 10-gauge wood screws before installing your shutter. High impact-resistant windows are optimal for windows that are not easily fitted with Water Damage shutters or those that are hard to reach. Make sure to install your impact resistant system on the sliding glass doors because they are larger and more vulnerable to wind damage and debris than regular windows. If these doors cannot be replaced, then at the very least install shutters.

Cleanup A Mobile Home Rental

Except as provided in this chapter, the landlord may recover actual damages and obtain injunctive relief for any noncompliance by the tenant with the rental agreement or AS 34.03.120 . (d) An order of abatement entered by a court under AS 09.50.170 terminates a rental agreement on the premises subje  read more..

Surviving A Tornado

Risk Assessment: Wind/Tornadoes Description The term "straight-line winds" is used to distinguish common, non-rotating winds from tornado-related winds. Straight-line winds are responsible for most thunderstorm wind damage, Wind Damage Surviving A Tornado with wind speeds in excess of 100 miles per hour on occasion.  read more..

Cost To Remove Mold From A Basement

Molds are part of the natural environment. Outdoors, molds play a part in nature by breaking down dead organic matter such as fallen leaves and dead trees, but indoors, mold growth should be avoided. Molds reproduce by means of tiny spores; the spores are invisible to the naked eye and float th  read more..

Mold Remediation From Colorado Flooding

Places that are often or always damp can be hard to maintain completely free of mold. If there's some mold in the shower or elsewhere in the bathroom that seems to reappear, increasing ventilation (running a fan or opening a window) and cleaning more frequently will usually prevent mold from recurri  read more..

Structural Drying

There are many factors when dealing with the Sewage Cleanup Structural Drying remediation of the problem. Among these problems are the cause of the sewage contamination, the types of water-damaged materials in your building like are they organic or synthetic, are the surfaces porous, semi-porous, or nonporous, the sewag  read more..

Forensic Cleaning And Training In Florida

The term "contaminated laundry" was used in the proposed standard in the description of paragraph (d)(4)(iv) housekeeping, but no definition was provided for the term. Crime Scene Cleanup Forensic Cleaning And Training In Florida The final standard contains a definition "contaminated laundry". 

This term is   read more..

Lead Was Used For Many Years In Plumbing

Testing your home's drinking water is the only way to confirm if lead is present. Most water systems test for lead at a certain number of homes as a regular part of water monitoring. These tests give a system-wide picture of whether or not corrosion is being controlled but do not reflect conditions   read more..

Mold Remediation

So your tenants have moved out. So your tenants without giving you notice and may have moved out. Now you have the task of going in and Tenant Move Out Cleanup Mold Remediation cleaning up. There are so many scenarios on this it's unbelievable. Hopefully you had good tenants and they left the place in decent shape, however this  read more..

Get Rid Of The Dead Mice Smell In Vents

Occasionally a raccoon, skunk, tree squirrel, or other animal will find a suitable shelter in or under a house, shed, or other structure. These animals may occupy an area sporadically, using the site only two or three consecutive days or nights usually until available food sources are exhausted. How  read more..

Dehumidify A Basement Without Electricity

The reheat energy is free and the penalties of increased refrigeration or the expense of additional cooling energy are avoided. The net effect of this cycle is identical to that of the run-around enhancements with two beneficial exceptions: Dehumidification Dehumidify A Basement Without Electricity (1) A precooling coil is not required and (2  read more..