Mold Remediation >> Mold Poisoning Symptoms

What is mold? molds are simple, microscopic organisms, found virtually everywhere, indoors and outdoors. molds can be found on plants, foods, dry leaves, Mold Poisoning Symptoms and other organic material. molds are needed for breaking down dead material. 

mold spores are very tiny and lightweight, and this allows them to travel through the air. mold growths can often be seen in the form of discoloration, ranging from white to orange and from green to brown and black. When molds are present in large quantities, Mold Poisoning Symptoms they can cause allergic symptoms similar to those caused by plant pollen.

Should I be concerned about mold in my home?
Yes, if the contamination is extensive. When airborne mold spores are present in large numbers, Mold Poisoning Symptoms they can cause allergic reactions, asthma episodes, infections, and other respiratory problems for people. 

Exposure to high spore levels can cause the development of an allergy to the mold. mold can also cause structural damage to your home. Similarly, Mold Poisoning Symptoms when wood goes through a period of wetting, then drying, it can eventually warp and cause walls to crack or become structurally weak.

What does mold need to grow?
For mold to grow, it needs:

  • food sources - such as leaves, wood, paper, or dirt
  • a source of moisture
  • a place to grow

Can mold become a problem in my home?
Yes, if there is moisture available to allow mold to thrive Mold Poisoning Symptoms and multiply. The following are sources of indoor moisture that may cause problems:

  • flooding
  • backed-up sewers
  • leaky roofs
  • humidifiers
  • mud or ice dams
  • damp basement or crawl spaces
  • constant plumbing leaks
  • house plants - watering can generate large amounts of moisture
  • steam from cooking
  • shower/bath steam and leaks
  • wet clothes on indoor drying lines
  • clothes dryers vented indoors
  • combustion appliances (e.g. stoves) not exhausted to the outdoors

CAUTION:
If you see moisture condensation on the windows or walls, it is also possible that you have a combustion problem in your home. It is important to have sufficient fresh air available for fuel burning appliances, such as the furnace, Mold Poisoning Symptoms water heater, stove/range, clothes dryer, as well as a fireplace. A shortage of air for these appliances can result in back drafting of dangerous gases such as carbon monoxide into the home. 

To prevent back drafting of air, you need either open vents or Mold Poisoning Symptoms a ventilation system that brings fresh air into the home to replace air that is exhausted out. Have your local utility company or a professional heating contractor inspect your fuel-burning appliances annually.

Flood Damage

In the ideal worlds, edifices can be designed so that flooding can never happen; however, in the real world, water sometimes gets out of control in all edifices. When a water emergency happens, rapid reaction to seepage, spillage, flooding, water damage, or backups has most benefits. Rapid re  read more..

Will Using Dehumidifier Get Rid Of Mold In A Room

In addition to correctly installing a vapor barrier, it is important to provide adequate ventilation of spaces where moisture can build up. Most building codes require that attics and crawl spaces be ventilated, Dehumidification Will Using Dehumidifier Get Rid Of Mold In A Room and some require a minimum one-inch clear airspace above the insulation for ve  read more..

Debris Removal

Other states might be in the prohibit transfer of any property where illegal drugs, like meth were manufactured unless the officials have determined the site was fit for use or, if not fit for use, unless the property seller has made a full written disclosure to the prospective property buyer  read more..

MOLD AND WATER DAMAGE FROM FLOOD RESPONSE

FLOOD RESPONSE - WATER DAMAGE AND MOLD HOW DO I PROPERLY CLEAN UP MY HOME IF IT HAS BEEN FLOODED OR HAS WATER DAMAGE? First, make sure electricity and natural gas or propane tanks are shut down. The Centers for Disease Control and Prevention (CDC) recommends that electricity and Mold Remediation MOLD AND WATER DAMAGE FROM FLOOD RESPONSE   read more..

How To Report A House Being Used As A Meth Lab

As a result of these limitations, it is necessary that the employer evaluate glove selection and use to prevent employee exposure as Meth Lab Cleanup How To Report A House Being Used As A Meth Lab specified in 29 CFR 1910.132(d). Guidance on conducting in-use testing methods for glove selection is available.8 Direct Reading Patches/Charcoal Felt Pads I  read more..

Cost To Remove Mold From A Basement

Molds are part of the natural environment. Outdoors, molds play a part in nature by breaking down dead organic matter such as fallen leaves and dead trees, but indoors, mold growth should be avoided. Molds reproduce by means of tiny spores; the spores are invisible to the naked eye and float th  read more..

Eliminate Mold And Mildew On Basement Walls

Permitting
 You or your moving contractor will have to obtain permits to move the house on public roads or other rights-of-way. These permits may be required by local governments, highway departments, and Basement Drying Eliminate Mold And Mildew On Basement Walls utility companies, not only in the jurisdiction from which your ho  read more..

How To Paint Over Fire Damage On Drywall

The president of NFPA (National Fire Protection Association) today called for all nursing homes in the U.S. to be equipped with fire sprinklers, in the wake of two recent nursing home fires in Hartford and Nashville, Fire Damage How To Paint Over Fire Damage On Drywall where a total of 24 people died. (See NFPA's fact sheet on nursing home fire s  read more..

Ceiling Leak Repair From Frozen Pipe

The first drying phase can be modeled by the normal diffusion equation (Equation 2) for which analytic solutions can be found in the literature (e.g., Baehr and Stephan 2003; Hens 2007; and Tautz 1971). The second drying phase is Structural Drying Ceiling Leak Repair From Frozen Pipe assumed to start at critical moisture content.  <  read more..

Lead Paint Removal Products

If the need for lead paint abatement can be clearly demonstrated, and if the contaminated features and finishes are important to the preservation of the property's historic character, the following priorities should be used. These are ranked on the principle of minimal intervention.1. Removal of lea  read more..