Asbestos Abatement >> Asbestos Flooring

Question 1: Are we correct that Asbestos Flooring floor tile cleaning activities (normal maintenance such as stripping and buffing operations) are covered under both the Asbestos flooring General Industry Standard (§1910.1001) and the Asbestos flooring Construction Standard (§1926.1101)? 

Answer: Yes. Both standards contain the same requirements for care of Asbestos-containing flooring material. The Asbestos Flooring requirements are at 29 CFR 1910.1001(k)(7) and 29 CFR 1926.1101(l)(3). 

Question 2: Are we correct that for normal cleaning (routine stripping and buffing) that the Asbestos flooring General Industry housekeeping procedures apply, Asbestos Flooring however the Asbestos flooring Construction Standard applies when floor tile clean-up activities are performed as a result of or incidental to a Class I, II or III job? 

Are we also correct, that asbestos flooring floor tile cleaning under the Construction standard is considered a Class IV job? Answer: Stripping or buffing asbestos flooring-containing flooring material previously soiled with asbestos flooring-containing dust or Asbestos Flooring debris from a Class I, II, or III Asbestos Flooring job is not part of the clean-up activity. 

The clean-up activity consists of picking up the debris and vacuuming up the dust. As such, Asbestos Flooring stripping or buffing asbestos flooring-containing flooring material does not come under any of the designated classes of asbestos flooring work defined in the Construction Asbestos flooring Standard. 

The stripping or buffing of asbestos flooring-containing flooring material usually comes under the scope of the General Industry Asbestos flooring Standard. However, stripping or buffing of the flooring material comes under the scope of the Construction Asbestos Flooring Standard if a construction company does it as part of the completion of a construction project. 

Question 3: Both standards discuss stripping operations and [stipulate] that low abrasion pads, wet methods, and Asbestos Flooring speeds lower than 300 rpm must be employed. If higher speed machines are used and current Negative Exposure Assessment (NEA) data exists (by TEM) showing the PEL was not exceeded, is it necessary to submit a written alternative work procedure and/or seek a variance? 

Answer: The Construction Asbestos flooring Standard does not allow the use of alternative procedures Asbestos Flooring for care of asbestos flooring-containing flooring material. The Standard makes allowances for using alternative control methods for only Class I or II asbestos flooring work. 

The fact that the asbestos flooring PELs are not exceeded when the floor stripping uses low abrasion pads at speeds greater than 300 revolutions per minute (rpm) is not a sufficient condition Asbestos Flooring to warrant the receipt of a variance permitting such use. 

In order to receive a variance, Asbestos Flooring the employer must have implemented some means of maintaining asbestos flooring aerosol levels in the employees' breathing zones at levels equal to or less than the levels occurring at speeds lower than 300 rpm. Question 4: While the Construction Standard discusses submitting alternative work procedures, the General Industry Standard does not. 

How does one handle an alternative work procedure regarding the General Industry Standard? Answer: As we noted in our reply to your third question, Asbestos Flooring the Construction Asbestos flooring Standard makes allowances for alternative control methods for only Class I or II asbestos flooring work. 

Therefore, whether the stripping or buffing of asbestos flooring-containing flooring material is covered by the Construction Asbestos flooring Standard or the General Industry Asbestos Flooring Standard, Asbestos Flooring the employer who wishes to use alternative stripping or buffing procedures must seek a permanent variance.

Radon Mitigation

Why is radon the public health risk that it is? EPA estimates that about 20,000 lung cancer deaths each year in the U.S. are radon -related. Exposure to radon is the second leading cause of lung cancer after smoking. Radon Mitigation Radon Mitigation is an odorless, tasteless and invisible gas produced by the decay of natural  read more..

How To Remove The Mildew Smell From A Flooded Base

Backhoes (power shovels) are available in a wide range of sizes, down to small "walk-behind” units capable of maneuvering in tight spaces like residential lots. Full foundation excavation with conventional backhoes is the base Basement Drying How To Remove The Mildew Smell From A Flooded Base case. Along with high cost, this method leads to very large im  read more..

How To Get Ready For A Hurricane

Flash floods can occur within a few minutes or hours of excessive rainfall, a dam or levee failure, or a sudden release of water held by an ice jam. Flash floods often have a dangerous wall of roaring water carrying rocks, mud and other debris. Overland flooding, Emergency Board up How To Get Ready For A Hurricane the most common type   read more..

How To Clean Smoke From Walls And Floors After Grease Fires

After the 1974 electronic system fire in Poitiers France, CNET developed what is considered the first modern test of corrosivity [70]. A number of other standards have since been developed that utilize a variety of fire and exposure models as well as several different methods of reporting results. T  read more..

Remove Toxic Smoke Damage From An Apartment Fire

The newly-created Coalition for Fire-Safe Cigarettes issued a call to the tobacco companies today to produce and sell only "fire-safe ” cigarettes nationwide. Fire Damage Remove Toxic Smoke Damage From An Apartment Fire

The Coalition, which is being launched today, is a national group of fire service members, consumer, e  read more..

The Dangers Of Raw Sewage

Establish temperature control to enhance the evaporation rate and effectiveness of ventilation or dehumidification systems in use. All solid waste must be collected and discarded. Use dehumidifiers, fans, window air conditioners and open windows to aid in the drying process when available. Exchange   read more..

Emergency Board Up_Chain Link Fence Security Optio

During a hurricane, homes may be damaged or destroyed by high winds and high waves. Debris can break windows and doors, allowing high winds inside the home. In extreme storms, such as Hurricane Andrew, the force of the wind alone can cause weak places in your home to fail. After Hurricane Andre  read more..

Lead Poisoning Questions And Answers

California has enacted landmark legislation to prevent childhood lead poisoning. This legislation has established the Childhood Lead Poisoning Prevention Branch (CLPPB), a children's environmental health program offering multi-layered solutions to this complex problem. What is lead poisoning? Lead   read more..

Animals digging in my yard

When it's obvious that your lawn has sustained some kind of animal damage whether it's creating mounds, tunneling or just plain digging. In order to correct the problem first you must identify the kind of animal that is created it. Depending on which part of the country you live in might at le  read more..

Learn Fire Damage Electronic Repair

Static and dynamic burn-in shall be performed at maximum recommended operating supply voltage @ TA = 125 C . Biasing conditions including the value of RL shall be selected to assure that the junction temperature shall not exceed Tj max specified for the device type.2/ See MIL-HDBK-1331: Parameters t  read more..