Flood Damage >> Structural Drying

As the materials begin to dry, the small amounts of heat or dehumidification can be introduced to the building. Use of mechanical means will require some caution, none of these mechanical devices should be used when Structural Drying makes their operation dangerous. Ventilation will remain the primary means of removing the interior moisture. . All of these mechanical devices must be used in conjunction with a strict ventilation plan designed to exhaust the moisture-laden air.

  1.  Beware of using heavy industrial drying equipment to remove the moisture at a very fast pace. You are very likely to cause permanent damage to the wood and plaster and if heaters are to be used without ventilation, the relative humidity in the building’s interior may actually increase and the further spread the Structural Drying. If the air heaters are fuel powered, the lack of good ventilation can be very dangerous to the persons inside the building. The enclosed portions of your building, such as the wall cavities, might retain water damage for long periods of time which could pose a danger particularly to the wooden elements such as wall studs, floor joists, and the columns.
  2.  It could be necessary to open the walls and remove the insulation, later sections of this article contain specific recommendations. When the floodwaters recede, you will have to rinse remaining mud, dirt and Structural Drying debris from all surfaces with fresh clean water as soon as possible. It is much safer and easier to remove the mud while it is still wet. Do not wait until the flood damaged material is dry, make sure that all of your electricity is turned off before cleaning with clean water. Avoid using any high pressure water on historic materials and also exercise extreme care when you're washing decorative features and water damaged or loosened elements.
  3.  The silt and mud will slowly accumulate not only on the floor and other furnishings, but in the interior wall cavities as well. Always, be sure to open your electrical outlets and the mechanical chases and rinse these Structural Drying areas thoroughly. Check your wiring and the connections for water damage and repair as required. Let areas thoroughly dry before closing any of them. Check your heating and air conditioning ducts and clean out any silt, mud or dirt before turning on the units. Large air-conditioning systems may need to be completely dismantled or cleaned by a professional.
  4.  To clean any remaining dirt and Structural Drying stains, use a standard non-sudsing household cleaning product as directed by the maker. Extra special care should be used when working on or around historic water damaged materials. After a thorough cleaning, use a disinfectant to kill the germs, bacteria, and odor damage left by the floodwaters. Keep in mind that all floodwaters and the remaining silt are contaminated by raw sewage and toxic chemicals. Protect your eyes, mouth, and your hands, and always wear a mask and rubber gloves when you're cleaning out Structural Drying debris left by contaminated floodwaters. Use industrial disinfectants to wash your hands before you eat.

Carpet Stain Removal Tips

Structural drying is an important step in the chain of work concerned with lumber scheming. Not, only should the worker be familiar with structural drying procedures and equipment employed, he, ought to become acquainted with the traits of the lumber with which he is concerned in correlation to sche  read more..

Lead Paint Exposure Registry In California

Legislation in 1986 created a statewide system for tracking lead poisoning cases in children and adults in California (California Health and Safety Code Section 124130). Laboratories are required to report electronically all blood lead levels (BLLs) for persons tested Lead Paint Removal Lead Paint Exposure Registry In California in California to  read more..

Water Damage House Mold

Stages of Remediation Process The fungal remediation process consists of the following basic elements:1. Identifying and correcting the source of moisture and fungal contamination 2. Controlling the contaminated area to prevent spreading of fungi 3. Source removal of the fungi, contaminated dus  read more..

Know If A Radon Mitigation System Is Working

Administrative Procedures for Mail-In Tests After EPA accepts an Application for a mail-in device, the applicant will be scheduled for his or her device performance test. The RQAC will send a notice to the applicant requesting the appropriate device(s) prior to the performance test date. Applicant f  read more..

Structural Drying

There are lots of reasons that water may get into your electronic components, causing damage. If the component is powered up at the time the water is introduced to the electronic component, it may not be repairable. This is something that needs to be determined by a professional Electronic Restoration Structural Drying technici  read more..

Hurricane Roof Damage

Experts describe the following progression during gable-end collapse: typically, the gable-end popped out due to suction on the leeward side of the building and the loss of sheathing, or Wind Damage Hurricane Roof Damage to a combination of suction and increased pressure resulting from breached openings in the shell.&  read more..

Storm Damage

If you own a mobile home in an area that has extreme thunderstorms with high winds you know the likelihood of the skirting around your home coming loose and blowing off. This will of course leave your crawlspace open to the elements and being vulnerable to Crawl Space Drying Storm Damage. There are many people that fac  read more..

OSHA Lead Paint In Construction Standard

In the OSHA Lead in Construction Standard, manual sanding is listed as a work method that, in the absence of previous exposure data, is initially presumed to expose employees to lead in excess of 50 mg/m3 but not in excess of 500 mg/m3 . However, the arithmetic mean for the nine 30-min exposures in   read more..

Get Rid Of A Dead Animal Smell In The Wall

Simply banging on the ceiling, wall, or floor in the vicinity of the animal may cause it to vacate; also, your initial search for young may have already made the animal uncomfortable enough to leave.Alternatively, with a powerful flashlight or headlamp containing fresh batteries, and Odor Control Get Rid Of A Dead Animal Smell In The Wall weari  read more..

Roof Leak Repair Cost

As an option to securing the conductors with stripping plies, conductor connectors that do not rely on prongs (such as the one shown in Figure 6) could be used. However, because the magnitude of the dynamic loads induced by the conductor are unknown Structural Drying Roof Leak Repair Cost and because of the lack of data on   read more..