Lead Paint Removal >> Get A Lead Abatement License

You might desire a respirator when,for example, you have received medical advice that your lead absorption should be decreased. Or, you may intend to have children in the near future, and want to reduce the level of lead in your body to minimize adverse Get A Lead Abatement License reproductive effects. 

While respirators are the least satisfactory means of controlling your exposure, they are capable of providing significant protection if properly chosen,fitted, worn, cleaned, maintained, Get A Lead Abatement License and replaced when they stop providing adequate protection. Your employer is required to select respirators from the types specified in the Respiratory Protection Standard, Section 5144(d)(3)(A)1. 

Any respirator chosen must be approved by the National Institute for Occupational Safety and Health (NIOSH) under the provisions of 42 CFR part 84. This respirator selection table will enable your employer to choose a Get A Lead Abatement License type of respirator which will give you a proper amount of protection based on your airborne lead exposure. 

Your employer may select a type of respirator that provides greater protection than that required by the standard; that is, one recommended for a higher concentration of lead than is present in your workplace. For example, a powered air purifying respirator (PAPR) is much more protective than a typical negative pressure respirator, Get A Lead Abatement License and may also be more comfortable to wear. 

A PAPR has a filter, cartridge or Get A Lead Abatement License canister to clean the air, and a power source which continuously blows filtered air into your breathing zone. Your employer might make a PAPR available to you to ease the burden of having to wear a respirator for long periods of time. The standard provides that you can obtain a PAPR upon request. 

Your employer must assure that your respirator face piece fits properly. Proper fit of a respirator face piece is critical. Obtaining a proper fit on each employee may require your employer to make available two or Get A Lead Abatement License three different mask types. 

In order to assure that your respirator fits properly and that facepiece leakage is minimized, Get A Lead Abatement License your employer must give you either a qualitative fit test or a quantitative fit test as specified in Appendix A of the Respiratory Protection standard located at section 5144. You must also receive from your employer proper training in the use of respirators. 

Your employer is required to teach you how to wear a respirator, to know why it is needed, and to understand its limitations. The standard provides that if your respirator uses filter elements, Get A Lead Abatement License you must be given an opportunity to change the filter elements whenever an increase in breathing resistance is detected. 

You also must be permitted to periodically leave your work area to wash your face and respirator facepiece whenever necessary to prevent skin irritation.If you ever have difficulty in breathing during a fit test or while using a respirator, Get A Lead Abatement License your employer must make a medical examination available to you to determine whether you can safely wear a respirator. 

The result of this examination may be to give you a positive pressure respirator(which reduces breathing resistance) or Get A Lead Abatement License to provide alternative means of protection. V. Protective Work Clothing and Equipment— subsection (g) If you are exposed to lead above the PEL as an 8-hour TWA, without regard to your use of a respirator.

If you are exposed to lead compounds such as lead arsenate or lead azide which can cause skin and eye irritation, your employer must provide you with protective work clothing and equipment appropriate for the hazard.If work clothing is provided, Get A Lead Abatement License it must be provided in a clean and dry condition at least weekly, and daily if your airborne exposure to lead is greater than 200 µg/m3. 

Appropriate protective work clothing and equipment can include coveralls or similar full body work clothing, gloves, hats, shoes or disposable shoe coverlets, Get A Lead Abatement License and face shields or vented goggles. Your employer is required to provide all such equipment at no cost to you.In addition, your employer is responsible for providing repairs and replacement as necessary, and also is responsible for the cleaning, laundering or disposal of protective clothing and equipment. 

The standard requires that your employer assure that you follow good work practices when you are working in areas where your exposure to lead may exceed the PEL. With respect to protective clothing and equipment, Get A Lead Abatement License where appropriate, the following procedures should be observed prior to beginning work: 

1. Change into work clothing and shoe covers in the clean section of the designated changing areas; 2. Use work garments of appropriate protective gear, including respirators before entering the work area; Get A Lead Abatement License and 3. Store any clothing not worn under protective clothing in the designated changing area. Workers should follow these procedures upon leaving the work area: 

1. HEPA vacuum heavily contaminated protective work clothing while it is still being worn. At no time may lead be removed from protective clothing by any means which result in uncontrolled dispersal of lead into the air; 2. Remove shoe covers and Get A Lead Abatement License leave them in the work area; 3. Remove protective clothing and gear in the dirty area of the designated changing area. 

Remove protective coveralls by carefully rolling down the garment to reduce exposure to dust. 4. Remove respirators last; Get A Lead Abatement License and 5. Wash hands and face. Workers should follow these procedures upon finishing work for the day (in addition to procedures described above): 1. Where applicable, place disposal coveralls and shoe covers with the abatement waste; 

2. Contaminated clothing which is to be cleaned, laundered or disposed of must be placed in closed containers in the change room. 3. Clean protective gear, including respirators, Get A Lead Abatement License according to standard procedures; 4. Wash hands and face again.If showers are available, take a shower and wash hair.If shower facilities are not available at the work site, shower immediately at home and wash hair. 

VI. Housekeeping—subsection (h) Your employer must establish a housekeeping program sufficient to maintain all surfaces as free as practicable of accumulations of lead dust. Vacuuming is the preferred method of meeting this requirement, Get A Lead Abatement License and the use of compressed air to clean floors and other surfaces is generally prohibited unless removal with compressed air is done in conjunction with ventilation systems designed to contain dispersal of the lead dust. 

Dry or wet sweeping, shoveling, or brushing may not be used except where vacuuming or Get A Lead Abatement License other equally effective methods have been tried and do not work. Vacuums must be used equipped with a special filter called a high-efficiency particulate air (HEPA) filter and emptied in a manner which minimizes the reentry of lead into the workplace.

Fire Damage

Odor Control, Fire damage


During a fire, the smoke could permeate the walls and other surfaces and could drift through the household ducts, where it can become trapped. If the smoke is not properly removed, smoke odor reoccurs from time to time, especially during the warm or damp  read more..

Water Damage Electronic Restoration Classes

When candidate plug or receptacle D-subminiature, microminiature or printed circuit connectors are submitted for qualification, completely assembled mated pairs shall be used. Connectors shall have a full complement of contacts. For Level 1 qualification, three mated pairs shall be prepared. For Lev  read more..

Asbestos Flooring

Question 1: Are we correct that Asbestos Abatement Asbestos Flooring floor tile cleaning activities (normal maintenance such as stripping and buffing operations) are covered under both the Asbestos flooring General Industry Standard (§1910.1001) and the Asbestos flooring Construction Standard (§1926.1101)?  <  read more..

Lead Paint Exposure To Workers In California

Occupational Safety and Health Administration (OSHA) Welding Safety Orders for hot work on painted steel structures require that lead-based paint be stripped back "a sufficient distance from the area to be heated to ensure that the temperature of the unstripped metal will not be appreciably raised."  read more..

Small Contractors And Lead Paint

Small contractors are an especially difficult audience to reach with a safety message, and yet there are thousands of them across the United States who, on a daily basis, direct thousands of employees in their work. Most construction companies are small, and the way in which health and safety practi  read more..

Effects Of Black Mold

The American Lung Association of the Northeast expresses its deepest sympathy to those affected by the devastation of Hurricane Sandy. As the cleanup from Hurricane Sandy continues, the Lung Association is reminding residents of affected areas to keep their lung health in mind when cleaning up from   read more..

Clandestine Drug Labs

Clandestine drug labs are found throughout Indiana. They are found in homes, apartments, hotel and motel rooms, and mobile homes.When they seize a drug lab, law enforcement agencies remove bulk chemicals and drug making equipment from the site. However, residual Meth Lab Cleanup Clandestine Drug Labs contamination often remains  read more..

Water Extraction

There are many ways to control moisture in your home, fix leaks and seepage. If water is entering the house from the outside, your options range from simple landscaping to extensive excavation and waterproofing. (The ground should slope away from the house.) Water in the basement can result f  read more..

Lead based Paint Is A Common Source Of Lead Poison

Asbestos-containing materials and lead-based paint have the potential to adversely affect human health and the environment. If properly handled, however, the risks are substantially reduced. The abatement of asbestos-containing material and lead-based paint is regulated by various federal, state and  read more..

Smoke Damage Restoration Tips

Gandhi [98,99] performed some simple modeling of three types of gas collections systems that could be used in corrosion tests, the CNET test, the cone corrosimeter, and a third system that utilized a piston cylinder chamber. He used the mass fraction of an arbitrary corrosive component of the fire e  read more..