Dehumidification >> When Is Dehumidification Required?

The main cooling coil without being re-evaporated by radiant or conducted heat. The main cooling coil must be When Is Dehumidification Required? selected at a coil face velocity at least 150 fpm below the maximum cataloged face velocity to ensure that moisture does not carry over onto a reheat coil (liquid water carryover onto an active reheat coil results in additional energy consumption and humidification).

AHU fans and motors (if the motor is in the air stream) should be located downstream from the recuperative reheat system for optimum effectiveness. If a supplementary reheat coil is When Is Dehumidification Required? used and its leaving-air temperature is above 100 F, then the fan motor must be selected for reliable operation at the actual temperature conditions at the motor. 

It may be necessary to derate the motor and use Class F or H high temperature motor-winding insulation. Special motors are not required for recuperative-reheat systems not equipped with supplementary reheat coils. 

Because of the possibility of moisture condensing on precooling heat-transfer surfaces during part-load operating conditions, provisions for When Is Dehumidification Required? collecting and draining condensate must be made. Heat-exchange surfaces will accumulate particulate even with well maintained filters. Surfaces should be accessible and cleanable without difficulty or high cost.

The fifth recuperative-dehumidification enhancement is superior to the other four in many respects because it achieves almost the same result with a single coil located downstream from the main cooling coil. The single coil reduces first cost, When Is Dehumidification Required? halves the air-side friction of the recuperative elements, and requires no space or modifications upstream from the main cooling coil. 

With the fifth enhancement, which is applicable only to systems using refrigerant coils served by compressors, the amount of reheat is limited. If a significant temperature rise is required, When Is Dehumidification Required? this enhancement may need to be combined with one of the other four. Details on each of the five recuperative-dehumidification enhancements follow. 

Run-around coils for enhanced dehumidification systems are not a new technology. They are well-described in texts from as long ago as 1939.
The psychrometric-chart analysis of run-around coils for precooling and reheating is identical to that for ordinary reheat (see sidebar) with one exception: 

The precooling coil cools the entering air from 84- to 72-F dry bulb (DB); therefore, the air entering the main cooling coil is cooler,When Is Dehumidification Required? which means that the main cooling coil does not have to remove as much heat. The reheat is provided not by an external source of expensive energy, but by the heat picked up by the circulating fluid in the precoil. 

The cycle and savings are illustrated in Figure 2. Figure 3 is a piping diagram showing that run-around coils require a small closed-loop piping system. When freezing is a possibility, the heat-transfer fluid is dilute ethylene glycol; at other times, it is water. The system requires a means of fluid makeup. A diaphragm compression tank normally is installed for fluid expansion. 

If water (not glycol) is used as the circulating fluid and chilled-water or heating-hotwater lines are in the vicinity, When Is Dehumidification Required? it is possible to achieve fill and fluid expansion with a 3 ⁄8-in. connection to the chilled-water or heating-hot-water closed loop. The expansion of the fluid in the small run-around system then would be provided by the fluid-expansion equipment in the larger system.

 With only a single connection between them, there can be no flow between the two systems except for that induced by density forces of water at different temperatures. The system requires a fractional-hp pump, electrical service, When Is Dehumidification Required? and controls. The recommended pump for the circuit is a 120/60/1 hermetically sealed pump that does not require a shaft seal. 

If a pump with a seal is used, the seal should be mechanical rather than packed to minimize or eliminate leakage. The closed-loop piping system is close-coupled and confined to the immediate vicinity of the two coils. 

Once the circulating fluid is charged into the system, there is little possibility of leakage; therefore, When Is Dehumidification Required? the fluid-makeup system can be a hose connection or a funnel fill valve. Coils and piping must include manual air vents at high points to vent air at the time of initial filling. The piping connections to each coil must be arranged for "counterflow.” 

The lines between the two coils (and the coil headers if exposed to ambient air) must be insulated to prevent external heat transfer. The pump should be located in the warm-fluid line. All of the air passing through the air-handling unit must pass through both coils. Any deviations from these guiding principles will cause a loss in performance.

Advantages of runaround coils are:  They can be widely separated and arranged in any position. If desired, When Is Dehumidification Required? a single precooling coil can be used in combination with multiple reheat coils. They carry the certification of the Air-Conditioning and Refrigeration Institute (ARI) and are available from at least 10 manufacturers. 

Because they are mass-produced using machinery, labor contributes little to their cost. They are, for all practical purposes, commodity items and,When Is Dehumidification Required? therefore, relatively inexpensive. Their selection can be made by the manufacturer or by the manufacturer’s coil-selection program using software on a personal computer. 

The precooling and reheat function can be controlled by pump on-off cycling or valve control. The preheat coil can be piped to a third coil in the exhaust-air stream to capture heat for preheating outside air during the winter.

Disadvantages. Disadvantages of run-around-coil systems are: Possible freezing if water is the When Is Dehumidification Required? circulating fluid (this can be overcome by using a dilute ethylene glycol solution selected to provide burst protection at the coldest anticipated entering-air temperature).
 
A 120-v, 60-cycle single-phase electrical circuit is required for the circulating pump. Air trapped in the coils, When Is Dehumidification Required? pump, and piping must be vented upon initial startup to ensure effective fluid flow and heat transfer. Figure 4 shows run-around coils at the entering and leaving sides of a specially configured unit.

Secure Your Roof Against Hurricane Winds

During a hurricane, homes may be damaged or destroyed by high winds and high waves. Debris can break windows and doors, allowing high winds inside the home. In extreme storms, such as Hurricane Andrew, Wind Damage Secure Your Roof Against Hurricane Winds the force of the wind alone can cause weak places in your home to fail.    read more..

Securing A Fenced Perimeter

Two keys to weather safety are to prepare for the risks and to act on those preparations when alerted by emergency officials. These are essential pieces to the Weather-Ready Nation.Refer to the Federal Emergency Management Agency's (FEMA) Ready.gov/hurricanes for comprehensive Emergency Board up Securing A Fenced Perimeter information on hu  read more..

Clean Smoke Damage From Walls And Fixtures After A

The U.S. Department of Homeland Security (DHS) today adopted five NFPA (National Fire Protection Association) Fire Damage Clean Smoke Damage From Walls And Fixtures After A standards for personal protective equipment for first responders. These adoptions will assist state and local procurement officials in selecting the best available protective equipment.  read more..

Mildew And Mold Control

The expression mildew is sometimes used in conjunction with mold. Mildew is mostly used to define kind of a specific mold fungus that grows on plants and is usually characterized by a soft downy, whitish or even silvery resemblance. Mildew is also sometimes used to define mold growing on your   read more..

How To Protect A Washer Dryer From A Flood

If there are no signs of problems, Flood Damage How To Protect A Washer Dryer From A Flood turn the power off again.Plug a lamp or small appliancein an outlet on the circuit youjust tested, or turn on a lightswitch. Be sure that the appliance you are using to test eachoutlet is working properly.

5.Turn the power  read more..

Remove Protein Smoke Odor From A Home

Collection recovery was postponed by the cleanup and refurbishment of the building and by a slow bureaucratic response to recovery, which resulted in staffing delays. The bulk of collection recovery by conservators was further slowed by the necessity to clean a gallery (which included some collectio  read more..

Water Extraction

An examination of the Odor Control Water Extraction in a building will typically disclose a large quantity of organic elements, most at strengths too low to have any visible unfavorable impact. The only trace of their existence might happen from the sense of smell. In the 1920s, there arose the idea that an o  read more..

Commercial Building Drying And Mold

MOLD/WATER DAMAGED MATERIALS Key Engineering Controls and Work Practices Discard all water-damaged materials, materials that are visibly coated with mold that cannot be properly cleaned, such as porous materials (e.g., carpeting, drywall, insulation), and Structural Drying Commercial Building Drying And Mold materials that have been wet   read more..

The Best Ways To Dehumidify

In this research, the concept of produced water desalination by using new HD process was laboratory investigated through a lab-constructed HD unit. The influences of the operation parameters such as feed water temperature and flow rate, carrying air flow rate on purified water quality, producti  read more..

Mold Problems Cause Asthma

Anyone can have asthma, including infants and adolescents. The tendency to develop asthma is often inherited; in other words, asthma can be more common in certain families. Moreover, certain environmental factors, such as viral infections, may bring the onset of asthma. Other environmental factors,   read more..