Odor Control >> Smoke Damage

The fire combustion process when wood is burned is never quite complete and the Smoke Damage from a wood burnt fire usually will contain a dark brown or black substance which has a very unpleasant odor. This tar looking substance is called creosote and is found almost anywhere in a wood house fire. At temperatures below 250 degrees F creosote will begin to condense on the surfaces of your stove pipes or the chimney flues.

  1. When the ambient temperature gets below 150 degrees F the creosote deposit may be thick, sticky and similar to tar. This tends to trap the carbon from any Smoke Damage which dries and bakes inside pipes and the flue, this powdery substance is extremely flammable. Creosote is much more of a problem with the wood stoves than fireplaces since the exhaust gases from wood stoves are cooler than those from your fireplace. The amount of creosote that is in condensing on the surfaces of the heating system varies according to the density of the Smoke Damage and the vapor from the fire, so less smoke means less creosote's and the temperature of the surface on which it is condensing, so the higher temperatures will reduce the chance of creosote condensation and the type and dryness of the wood being burned.
  2.  Creosote could build up to a dangerous thickness on the interior surface of the chimney and the draft opening might subsequently be reduced. A serious fire damage may be ignited if the creosote is allowed to build up. Most Smoke Damage problems with creosote are due to poorly constructed chimneys with a low draft and cold walls. You could reduce the amount of creosote problems in several ways. The smoke density could be lowered somewhat in an airtight stove by using smaller amounts of wood and stoking more often or by using larger pieces of dried wood. Creosote formation could be limited by leaving the air inlet or stove door slightly ajar after adding your wood to promote more rapid burning until the burnt wood is mostly reduced to charcoal, then close the inlet as needed.
  3. Allowing this extra amount of air causes more complete combustion and that lowers the potential Smoke Damage creosote-forming gases and generates additional heat to the surrounding space. Vapor in the flue pipe gases may be controlled by using the driest wood possible and also using only small pieces of wood during the mild weather when combustion is still relatively slow.
  4. The open stack temperature could be raised by insulating the vertical stove pipe connection so that it will cool as little as possible before reaching the upper chimney. Also using an insulated pipe will aid in increasing the overall stack temperature. Draft could be increased by having as few angles as possible between the heating appliance and the chimney, having the proper height and diameter and keeping the chimney in good condition and by having a separate flue pipe for each appliance. Also Smoke Damage use the proper sized stove flue pipe, in a larger chimney, the draft could be increased by decreasing the flue pipe size.

Lead Removal Debris Removal

Lead-based house paint was commonly used in homes up until the late 1970s, and was particularly usual before the 1950s. The most customary places to find lead-based house paint are places where high strength is needed, like doors, door frames, windows, woodwork, and furniture. Lead-based house paint  read more..

Questions And Answers On Lead Poisoning

Does the paint and dirt at my house have lead in it? If your home was built before 1978 it may have been painted inside and outside with paint that has lead in it. The dirt outside of these homes may also have lead in it. Have your paint and dirt tested for lead. Call your local Lead Poisoning Preve  read more..

How To Deal With An Elderly Hoarder

And then there's the odd story of Wolbachia. Most of us, I think, believe that genetics and evolution pretty much predetermine how we will reproduce ourselves. It seems unlikely that we have a choice about whether we procreate by mating with members of the opposite sex (as humans do) or Hoarding How To Deal With An Elderly Hoarder by  read more..

How To Read A Radon Test

COMPLY WITH EPA REQUESTS FOR INFORMATION All applicants and participants must provide EPA with information upon request. This compliance is an entrance and continuing requirement of the Radon Proficiency Program. Requests to participants, especially measurement service providers, Radon Mitigation How To Read A Radon Test may   read more..

Asbestos Removal Disposal In Ohio

This section applies to all occupational exposures to asbestos in all industries covered by the Occupational Safety and Health Act, except as provided in paragraph (a)(2) and (3) of this section. This section does not apply to  Asbestos Abatement Asbestos Removal Disposal In Ohio construction work as defined in 29 CFR 1910.12(b).    read more..

Contaminated Sewage Water

DEALING WITH WATER DAMAGE When should clean up begin? Clean up should begin as soon as it is safe to return to the building. Prompt and proper clean up is important for your health. Flood waters can contain microorganisms (such as bacteria, molds, and viruses), raw sewage, dead animals, Water Damage Contaminated Sewage Water&nb  read more..

How To Clean Up Fire Damage To Drywall

Lawmakers, fire officials, advocates and victims' families celebrated the passage of the Fire-Safe Cigarettes Bill on Tuesday at a state house reception. On July 8, Governor Romney signed the bill into law, Fire Damage How To Clean Up Fire Damage To Drywall making Massachusetts the sixth state in the country to require tobacco companies to sell  read more..

How To Remove Radon From A Basement

Category I Course Work As stated above, participants in the Residential Mitigation Service Provider component of the RPP must earn a minimum of eight (8) of the required sixteen (16) hours of continuing education every two years through approved Category I course work. Those with dual listings are r  read more..

Lead Paint Removal Regulations

What surfaces are not suitable for encapsulation? "Friction" and high profile (i.e., protruding window sills) surfaces are not suitable, regardless of their condition.Friction surfaces include: window jambs; glides; headers; some stops and parting beads; inside, close-fitting door jambs and stops; f  read more..

How To Clean Up After An Unattended Death

All employees are responsible for reporting suspected hazardous materials, hazardous wastes, industrial wastes, biohazards, sewage, or any unidentified material or waste incidents to the Fire Department. Crime Scene Cleanup How To Clean Up After An Unattended Death If the Fire Department determines there is a possibility that enforcement action   read more..