Odor Control >> Smoke Damage

The fire combustion process when wood is burned is never quite complete and the Smoke Damage from a wood burnt fire usually will contain a dark brown or black substance which has a very unpleasant odor. This tar looking substance is called creosote and is found almost anywhere in a wood house fire. At temperatures below 250 degrees F creosote will begin to condense on the surfaces of your stove pipes or the chimney flues.

  1. When the ambient temperature gets below 150 degrees F the creosote deposit may be thick, sticky and similar to tar. This tends to trap the carbon from any Smoke Damage which dries and bakes inside pipes and the flue, this powdery substance is extremely flammable. Creosote is much more of a problem with the wood stoves than fireplaces since the exhaust gases from wood stoves are cooler than those from your fireplace. The amount of creosote that is in condensing on the surfaces of the heating system varies according to the density of the Smoke Damage and the vapor from the fire, so less smoke means less creosote's and the temperature of the surface on which it is condensing, so the higher temperatures will reduce the chance of creosote condensation and the type and dryness of the wood being burned.
  2.  Creosote could build up to a dangerous thickness on the interior surface of the chimney and the draft opening might subsequently be reduced. A serious fire damage may be ignited if the creosote is allowed to build up. Most Smoke Damage problems with creosote are due to poorly constructed chimneys with a low draft and cold walls. You could reduce the amount of creosote problems in several ways. The smoke density could be lowered somewhat in an airtight stove by using smaller amounts of wood and stoking more often or by using larger pieces of dried wood. Creosote formation could be limited by leaving the air inlet or stove door slightly ajar after adding your wood to promote more rapid burning until the burnt wood is mostly reduced to charcoal, then close the inlet as needed.
  3. Allowing this extra amount of air causes more complete combustion and that lowers the potential Smoke Damage creosote-forming gases and generates additional heat to the surrounding space. Vapor in the flue pipe gases may be controlled by using the driest wood possible and also using only small pieces of wood during the mild weather when combustion is still relatively slow.
  4. The open stack temperature could be raised by insulating the vertical stove pipe connection so that it will cool as little as possible before reaching the upper chimney. Also using an insulated pipe will aid in increasing the overall stack temperature. Draft could be increased by having as few angles as possible between the heating appliance and the chimney, having the proper height and diameter and keeping the chimney in good condition and by having a separate flue pipe for each appliance. Also Smoke Damage use the proper sized stove flue pipe, in a larger chimney, the draft could be increased by decreasing the flue pipe size.

How To Stop A Basement Water Leak Waterproofing

The hydrologic cycle is the continuous circulation of water from land and sea to the atmosphere and back again : water evaporates from oceans, lakes, and rivers into the atmosphere. This water later precipitates as rain or snow onto the land where it evaporates or runs off into streams and rive  read more..

Snake Removal

There are many reasons that a snake would want to go into your basement safety, shelter, or to escape the heat. It's amazing how they can fit through the smallest cracks and the tiniest openings. However the Animal Damage Snake Removal happens you must act upon it quickly to keep any further infestations under contro  read more..

Basement Dehumidification

If you are not successful with cleaning your flood damaged carpet and mold and mildew occurs because you didn't dry it quickly enough, then you should try Basement Drying Basement Dehumidification. Try to lift up the carpeting to get a dehumidifier underneath of it. If the foam on the back of the carpeting gets torn in this proc  read more..

Requirements In The State Of Tennessee For Crime S

Bloodborne Pathogens are biological agents, which may be present in human blood and can cause disease. Examples of bloodborne pathogens include the hepatitis B virus, human immunodeficiency virus (HIV) and the organisms, Crime Scene Cleanup Requirements In The State Of Tennessee For Crime S which cause malaria. 

  read more..

How To Get Rid Of Water In My Basement

Flood Depth
The primary consideration in dry floodproofing, and the one that imposes the greatest limitations on the application of this method, is the effect of hydrostatic pressure. Because dry floodproofing prevents water from entering the house, Basement Drying How To Get Rid Of Water In My Basement the external hydrostatic   read more..

How To Dry A Moldy Wet Basement

Molds are fungi that grow best in warm, damp environments – like your flooded basement. If your home has been flooded and has been closed up for several days, you can assume it has been contaminated with Basement Drying How To Dry A Moldy Wet Basement mold. Mold and Health Some people are sensitive to molds – even dead molds. Exposure  read more..

How To Keep Mold And Mildew Out Of Basement Closets

Floods: Drying Out This publication is intended to give quick, brief answers to the many issues that arise after a flood. You will not find detailed instructions here, but the answers will direct you to short fact sheets and the sections of several Basement Drying How To Keep Mold And Mildew Out Of Basement Closets booklets that have detailed instructions.  read more..

Fire Damage Guitar Restoration Tips

In some parts the sensitivity of the input/output ESD protection circuits increases with temperature and these circuits can be turned on easily, at lower and/or shorter voltage spikes, than at room temperature. For this reason, Electronic Restoration Fire Damage Guitar Restoration Tips special care should be taken to prevent possible power li  read more..

How To Remove Tiles With Asbestos

Preparing the Work Area Disabling HVAC Systems: The power to the heating, ventilation, and air conditioning systems that service the Asbestos Abatement How To Remove Tiles With Asbestos restricted area must be deactivated and locked off. All ducts, grills, access ports, windows and vents must be sealed off with two layers of plastic to   read more..

Ceiling Leak Repair Cost

If the water level was less than 2½ feet, the wall material should be removed to a height of 4 feet to facilitate reinstallation of full sheets of drywall. If the water level was greater than 2½ feet, the wall material should be removed to a height of 8 feet or the ceiling junction, whichever is h  read more..