Odor Control >> Smoke Damage

The fire combustion process when wood is burned is never quite complete and the Smoke Damage from a wood burnt fire usually will contain a dark brown or black substance which has a very unpleasant odor. This tar looking substance is called creosote and is found almost anywhere in a wood house fire. At temperatures below 250 degrees F creosote will begin to condense on the surfaces of your stove pipes or the chimney flues.

  1. When the ambient temperature gets below 150 degrees F the creosote deposit may be thick, sticky and similar to tar. This tends to trap the carbon from any Smoke Damage which dries and bakes inside pipes and the flue, this powdery substance is extremely flammable. Creosote is much more of a problem with the wood stoves than fireplaces since the exhaust gases from wood stoves are cooler than those from your fireplace. The amount of creosote that is in condensing on the surfaces of the heating system varies according to the density of the Smoke Damage and the vapor from the fire, so less smoke means less creosote's and the temperature of the surface on which it is condensing, so the higher temperatures will reduce the chance of creosote condensation and the type and dryness of the wood being burned.
  2.  Creosote could build up to a dangerous thickness on the interior surface of the chimney and the draft opening might subsequently be reduced. A serious fire damage may be ignited if the creosote is allowed to build up. Most Smoke Damage problems with creosote are due to poorly constructed chimneys with a low draft and cold walls. You could reduce the amount of creosote problems in several ways. The smoke density could be lowered somewhat in an airtight stove by using smaller amounts of wood and stoking more often or by using larger pieces of dried wood. Creosote formation could be limited by leaving the air inlet or stove door slightly ajar after adding your wood to promote more rapid burning until the burnt wood is mostly reduced to charcoal, then close the inlet as needed.
  3. Allowing this extra amount of air causes more complete combustion and that lowers the potential Smoke Damage creosote-forming gases and generates additional heat to the surrounding space. Vapor in the flue pipe gases may be controlled by using the driest wood possible and also using only small pieces of wood during the mild weather when combustion is still relatively slow.
  4. The open stack temperature could be raised by insulating the vertical stove pipe connection so that it will cool as little as possible before reaching the upper chimney. Also using an insulated pipe will aid in increasing the overall stack temperature. Draft could be increased by having as few angles as possible between the heating appliance and the chimney, having the proper height and diameter and keeping the chimney in good condition and by having a separate flue pipe for each appliance. Also Smoke Damage use the proper sized stove flue pipe, in a larger chimney, the draft could be increased by decreasing the flue pipe size.

How To Remove Black Mold From The Attic

Serious Health Problems from Mold Exposure Typical symptoms reported from mold exposure include:- Respiratory problems - sneezing, asthma attacks, etc.- Nasal and sinus congesting or dry, hacking cough- Eye irritation - burning, watery, redness- Nose or Mold Remediation How To Remove Black Mold From The Attic throat irritation - sneezing fi  read more..

Waterproof A Basement For Severe Flooding

Remove water trapped within your walls. To check for water,take off the baseboard. Stick an awl or knife into the wall about 2 inches above the floor (just above the 2 X 4 wood sill plate). If water drips out, cut or Flood Damage Waterproof A Basement For Severe Flooding drill a hole large enough to allow water to drain freely. (Use a hand or cordl  read more..

How To Catch Birds In The Home In Arizona

The problem of starling damage to livestock feed has been documented in France and Great Britain, and in the United States. As the science of raising cattle for slaughter progressed from range to feedlot operations, the starling Animal Damage How To Catch Birds In The Home In Arizona problem intensified. 

The concent  read more..

Dehumidification

The influenced mechanisms of the structure’s main electrical and HVAC systems must be Structural Drying Dehumidification and decontaminated. Division of the influenced area from the uninfluenced areas must be re-created if necessitated preceeding to tear-out. Once achieved, machine-driven drying could begin. These expenses  read more..

Methamphetamine Manufacturing

Methamphetamine Manufacturing and Common Manufacturing ChemicalsIn Kentucky, the majority of known meth Meth Lab Cleanup Methamphetamine Manufacturing labs have used the Anhydrous Ammonia also known as theBirch or Nazi method (See Figure A, Methamphetamine Manufacturing Processes). These labs areable to produce small quantities of meth  read more..

How To Kill Mold In A Crawl Space

A properly sealed, moisture-protected, and insulated crawlspace will increase comfort, save on energy costs, improve the durability of the home, and reduce entry of moisture, radon, and other potential irritants or pollutants into the home. Crawl Space Drying How To Kill Mold In A Crawl Space Whichever design is followed, the keys to an  read more..

How To Measure Radon Levels

EPA Recommends the Following Testing Steps:Step 1.Take a short-term test. If your result is 4 pCi/L or higher, take a follow-up test (Step 2) to be sure.Step 2. Follow up with either a long-term test or a second short-term test: For a better understanding of your year-round average radon level, Radon Mitigation How To Measure Radon Levels  read more..

Carpet Cleaning Without Water

Constituents from six major chemical groups were measured: radionuclides, major and trace elements, organo chlorine pesticides and PCBs, PAHs, UWI compounds, and current-use pesticides. The results of the chemical analyses are presented in tables 2–7. Interpretations of data listed in this report a  read more..

Lead Paint Protection Requirements

Lead standard provides for a multiple physician review in cases where the employee wishes a second opinion concerning potential lead poisoning or toxicity. If an employee wishes a second opinion, he or she can make an appointment with a physician of his or her choice. This second physician will revi  read more..

Wet Carpet From A Plumbing Leak

Common Indoor Moisture Sources Include: Flooding, inadequate maintenance and failure of building materials and systems Roof leaks Plumbing leaks Overflow from tubs, sinks or toilets Firewood stored indoors Humidifier use Inadequate venting of kitchen and Water Damage Wet Carpet From A Plumbing Leak bath humidity Improper venting  read more..