Structural Drying >> Storm Damage

Woods are a byproduct of nature showing many inconsistencies. Cross-sectional (transverse) shrinkage isn’t always uniform. The quantity of shrinkage happening parallel with progress rings (tangential directions) ranges from one and one-half to two times as much as across, or at ninety degree angles to, the progress rings (radial directions) This difference in 6 directional shrinkages often causes warping in shape (cupping, diamonding and rectangular shapes from squares).

  1. A flat grain plank would shrink more in girth than a vertical grain plank of the same initial sizes. A flat grain plank from near the middle of a log would cup more than one sawn farther out from the middle. To further exacerbate these Storm Damage matters, the quantity of tangential and radial shrinkages (in per cent of greener dimensions per inch of dimensions), varied with the density of wood; i.e. values recorded for western larches and Douglas-firs are higher than that for redwoods, western red cedars and the western pines while they are lower than that for oak, hard maples and hickories when all are dried to the same humidity substance.
  2. Due to density variations within certain trees and between the trees (indicated by per cent summerwoods), actual shrinkages developing often would vary broadly from recorded values for these species. Published shrinkages values given for a species are average; it would be helpful if information included the variation in shrinkages to be expected during Storm Damage. Heavy shrinking allowed when sawing lumber to make up for variation in density and grain point results to a loss of footage. On the other hand, insufficient allowances result in a complete degradation from failure to surface out to standard sizes. Learning anything about variations odd to the timber sawn by a mill ought to be a valuable aid in reducing those losses, where practical.
  3. Not all of the portions of a plank reach the fibrous saturation point at the same time. The outer surfaces of a plank dry first and have the tendency to shrink, like change in humidity substance, progresses from the outside towards the middle of a plank (between opposite faces). Those results in the familiar development of Storm Damage stresses within a plank to cause case hardening, splits, checks, honeycombing and one form of collapses. Case hardening of lumber would result in very low total shrinkage values while collapses would result in significantly high values.
  4. Severity of stresses developed might be connected with the density of the wood in correlation to the conditions of humidity removal through the structural drying operation. Adjusting conditions to lumber traits is essential for Storm Damage; the same applies to segregation of lumber into groups with similar characteristics prior to Storm Damage. Undesirable vertical shrinkage often happens in many different types of lumber to cause twisting, crooking, bowing and cross breaks. Twisting happens where the vertical cells significantly vary in deviation from the axis of a plank (such as spirals, wavy and diagonal grains).

Signs Of A Hoarder

In late December, Lake Johanna Fire Department responded to a fatal house fire in Shoreview. The Department's response efforts were complicated by the "hoarding situation found inside the home. The Fire Department, as well as City and County staff, Hoarding Signs Of A Hoarder have become more aware of these hoar  read more..

Types Of Backup Preventions

Presented below are possible solutions that could be implemented by homeowners to protect their property from backups. This section assumes that sanitary sewage is backing up through plumbing fixtures located in a basement or lower level and the property owner has identified and Sewage Cleanup Types Of Backup Preventions eliminated all   read more..

How To Prevent Basement Condensation

Perlite is a mined volcanic glass material. When heated, water trapped in the glass matrix vaporizes. As it does so, it expands the heat-softened glass Basement Drying How To Prevent Basement Condensation material, creating a particle with a rough outer surface and an interior composed of closed-cell glass bubbles. He recommends use of this   read more..

How To Clean After Tenants

When the tenant moves out of a rental unit, the landlord has thirty (30) days in which to either return the entire security deposit plus interest if appropriate, or send a written statement of any deductions made from the deposit for repairs, cleaning, etc., the cost of each repair (supported by cop  read more..

How To Paint Over Fire Damage On Drywall

The president of NFPA (National Fire Protection Association) today called for all nursing homes in the U.S. to be equipped with fire sprinklers, in the wake of two recent nursing home fires in Hartford and Nashville, Fire Damage How To Paint Over Fire Damage On Drywall where a total of 24 people died. (See NFPA's fact sheet on nursing home fire s  read more..

Debris Removal

If you have a good lease you will be able to recoup some of your money. However most people do not have a thorough lease so water damage, and damage from mold, basic neglect are not covered in the lease. If you do have a good lease and the tenant fails to inform you that there is a water leak   read more..

How To Remove Hurricane Damage Debris In An Emerge

We agree with the initiatives FEMA is considering to improve the debris planning process. We will determine the status of this recommendation once we receive the detailed corrective action plan in FEMA s 90 day letter.Initiating Debris Operations The decisions made in the first few days after a disa  read more..

Proper Removal Of Lead Paint

You want to take good care of your family. You try to eat healthy foods. You take your children to the doctor for regular checkups. You try your best to protect your family from accidents and illness. You want to live in a safe neighborhood and home. But did you know your home might have Lead Paint Removal Proper Removal Of Lead Paint hidden  read more..

Lead Paint Abatement Training

The standard requires that hand washing facilities be provided where occupational exposure to lead occurs. In addition, change areas, showers (where feasible), and lunchrooms or eating areas are to be made available to workers exposed to lead above Lead Paint Removal Lead Paint Abatement Training the PEL. 

  read more..

How To Choose An Asbestos Removal

Vermiculite is a nonfibrous silicate mineral with many commercial and consumer applications. Its usefulness comes from its ability at high temperatures to expand (i.e., exfoliate) up to 20 times its original size (EPA 1991). Additionally, vermiculite has a high-ion exchange capacity, making it usefu  read more..