Wind Damage >> Water Removal

Tell your local Water Removal construction supply retailer the size and number of openings you require to cover to decide how many sheets to buy. To place plywood shutters you will require bolts, wooden or mason anchors, bigger washers, and 5/8 - inch outside-graded plywood. For windows that are 3 feet by 4 feet or smaller placed on a wooden framed house, use 1/4 -inch lag bolts and plastic-coated permanent anchors.

  1. The lag bolts shall penetrate the edge and frame surrounding the windows at least 1 1/2 inches. For bigger windows, utilize 3/8 –inch lag bolts that penetrate the edge and frame surrounding the Water Removal windows at least 2 1/2 inches. For windows 3 feet by 4 feet or littler placed on a mason house, use 1/4-inch expansion bolts and coated permanent expansion anchors. The expansion bolt shall penetrate the edge at the least 1 1/2 inches. For bigger windows, utilize 3/8 –inch expansion bolts that penetrate the edge at the least 1 ½ inches.
  2. The tools you will require are a circular or hand saw, a drill with the appropriately sized bits, hammers, and wrenches to fit the bolts. To be secure, use eye protections and labor gloves. Cut all of the Water Removal plywood to the measurements for every opening. Drill holes 2 1/2 inches from the outside edge of the plywood at every corner and at 12-inch intervals. Drill four holes in the middle vicinity of the plywood to relieve pressure during a typhoon. Spot the plywood over the opening and mark every orifice position on the outside edge. Drill holes with the appropriate size and type of bit for the anchors.
  3. Place the anchors, the Water Removal plywood, and the bolts to make certain they fit right. On wooden-framed houses, make sure that the anchors are secured into the solid wood that frames the door or window and not into the siding or the trim. Mark every Water Removal shutter so you will know where it is to be placed and store them and the bolts in an accessible spot. If the opening is bigger than one sheet of plywood, you will require making shutters with 2x4 bracing. This bracing could be two 2x4s at the middle and bottom of the two sheets of plywood, evenly spaced, with the 2-inch side attached to the inside of the storm shutter.
  4. Attach the 2x4s to the outside of the storm shutter with 2-inch, 10-gauge wooden screws before placing the shutter. The recommendations in this article are not intended to change local building law requirements or to serve as the only options for protecting your house from typhoon wind damage. For more information on protecting your house from typhoon wind damage, contact your local Water Removal construction officials; your local construction supply retailer; or a construction professional, such as an engineer, architect, or experienced contractors.

Water Extraction

Electronic data base consists of all the material that is Kept as Document restoration Water Extraction in your businesses office and the attempted prevention of the loss of this valuable electronic data base will depend on the routine daily backing-up of all computer server files. The section of material and instructional sk  read more..

How Do I Encapsulate And Dehumidify The Crawl Spac

This Guide for Home Energy Raters presents Guide Details that serve as a visual reference for each of the line items in the Water Management System Builder Checklist. Crawl Space Drying How Do I Encapsulate And Dehumidify The Crawl Spac The details are great tools for Rater education and will help Raters answer contractor and subcontractor questions.&nb  read more..

How To Remove Water From A Crawl Space

Molds are simple, microscopic organisms, present virtually everywhere, indoors and outdoors. Molds, along with mushrooms and yeasts, are fungi and are needed to break down dead material and Crawl Space Drying How To Remove Water From A Crawl Space recycle nutrients in the environment. 

For molds to grow and r  read more..

How To Get Rid Of Asbestos Material In California

This information will help you understand asbestos: what it is, its health effects, where it is in your home, and what to do about it. Even if asbestos is in your home, this is usually NOT a serious problem. The mere presence of asbestos in a home or a building is not hazardous. The danger is that a  read more..

Homeowner Asbestos Removal

Additional monitoring. Notwithstanding the provisions of paragraphs (d)(2)(ii) and (d)(4) of this section, the employer shall institute the exposure monitoring required under paragraphs (d)(2)(i) and (d)(3) of this section whenever there has been a change in the production, process, control &nb  read more..

Storm Damage Roof Leak

Hygrothermal building component simulation requires a complete set of storage and transport functions. Such functions are typically determined by the aid of material models defining a set of functions that are adjusted to basic material data. Basic material data consists of either single parameters   read more..

How To Clean Out A Trashed Apartment

Serving a Notice To Quit Notices of Termination of Tenancy (also called "Notices to Quit") from the landlord must be served on the tenant by: delivering the notice in person to the tenant or occupant; leaving the notice at the dwelling when the tenant is absent from the premises; or sending the noti  read more..

Remove Paint If You Dont Know If It Contains Lead

The standard also provides for a program of biological monitoring and medical surveillance for all employees exposed to levels of inorganic lead above the action level of 30 µg/m3 (TWA) for more than 30 days per year. The purpose of this document is to outline the medical surveillance provisions   read more..

How To Remove Lead Paint In Soil

Did you know that many homes built before 1978 have lead-based paint? Lead from paint, chips, and dust can pose serious health hazards. Read this entire brochure to learn: How lead gets into the body About health effects of lead What you can do to protect your family Where to go for more Lead Paint Removal How To Remove Lead Paint In Soil&n  read more..

Storm Damage

Applying for a reimbursement grant from FEMA can be a time-consuming but worthwhile process. Like many government agencies there are endless types of forms and finding the correct one may be difficult. Like any type of reimbursement there are deadlines where the forms would have to be submitt  read more..