Structural Drying >> After Roof Collapse

The standard provides flood, wind, and seismic resistant installation procedures. It also calls for elevating A Zone manufactured homes with the bottom of the main chassis frame beam at or above the BFE, not with the top of the floor at the BFE. How High Above the BFE Should a Building be After Roof Collapse Elevated? 

Ultimately, the building elevation will depend on several factors, all of which must be considered before a final determination is made: The accuracy of the BFE shown on the FIRM: If the BFE is suspect, After Roof Collapse it is probably best to elevate several feet above the BFE; if the BFE is deemed accurate, it may only be necessary to elevate a couple of feet above the BFE. 

Availability of Advisory Base Flood Elevations (ABFEs): ABFEs have been produced for coastal areas following Hurricanes Ivan, Katrina, and Rita. These elevations are intended to be interim recommendations until new FISs can be completed. Some After Roof Collapse communities have adopted ABFEs, but not all (see the Hurricane Katrina Recovery Advisory posted at http://www.fema.gov/pdf/rebuild/mat/reconst_guidance.pdf). 

Future conditions: Since the FIRM reflects conditions at the time of the FIS, some owners or jurisdictions may wish to consider future conditions (such as sea level rise, wetland loss, shoreline erosion, increased storm frequency/intensity, After Roof Collapse and levee settlement/failure) when they decide how high to elevate. 

State or local requirements: The state or local jurisdiction may require a minimum free board through its floodplain management regulations. Building code requirements: The International Building Code (IBC) requires buildings be designed After Roof Collapse and constructed in accordance with ASCE 24 (Standard for Flood Resistant Design and Construction). 

ASCE 24 requires between 0 and 2 feet of freeboard, depending on the building importance After Roof Collapse and the edition of ASCE 24 referenced. [footnote 3]Footnote 3. The 1998 edition of ASCE 24 is referenced by the 2003 edition of the IBC, and requires between 0 and 1 feet of freeboard. The 2005 edition of ASCE 24 is referenced by the 2006 edition of the IBC, and requires between 0 and 2 feet of freeboard. [end footnote] 

Critical and essential facilities: Given the importance of these facilities, some of which must remain operational during a hurricane, they should be elevated higher than most commercial and residential buildings. Building owner tolerance for damage, After Roof Collapse displacement, and downtime: Some building owners may wish to avoid building damage and disruption, and may choose to elevate far above the BFE (see Figures 12 and 13).Figure 12 caption. 

Ocean Springs, Mississippi, After Roof Collapse home elevated approximately 14 feet above the BFE. Katrina flooding was 4 feet below the elevated floor (photo taken after the storm surge had dropped several feet. Courtesy of Ocean Springs, Mississippi, fire chief). [end caption]Figure 13 caption. Pass Christian, Mississippi, home elevated on reinforced concrete columns in Zone A, with the bottom of the floor beam elevated approximately 9 feet above the BFE. 

Although Katrina flooding was approximately 4 feet above the top of the lowest elevated floor, After Roof Collapse the home sustained no structural damage. All other buildings in the vicinity were destroyed. [end caption]The Hurricane Katrina Summary Report on Building Performance (FEMA 548) recommends that critical and essential facilities be elevated to the 500-year flood elevation or based on the requirements of ASCE 24-05, whichever is higher. 

This recommendation may also be appropriate for residential and commercial structures, After Roof Collapse as well.The 500-year elevation can be approximated as 1.5 times the 500-year stillwater depth (500-year stillwater elevation minus the ground elevation) added to the ground elevation. This procedure is similar to the procedure used to calculate ABFEs, but with a different stillwater level.

[Begin text box]If the 500-year stillwater elevation (feet North American Vertical Datum of 1988 [NAVD] or feet National Geodetic Vertical Datum of 1929 [NGVD]) is not available, After Roof Collapse a rule of thumb can be used to approximate it as 1.25 times the 100-year stillwater elevation (feet NAVD or feet NGVD).[end text box]Coastal A Zones

The Coastal A Zone is the area where wave heights between 1.5 and 3.0 feet are expected during the base flood. It is recommended that buildings in this area, with a few exceptions, After Roof Collapse be designed and constructed similar to V Zone buildings. See the Hurricane Katrina Recovery Advisory at http://www.fema.gov/pdf/rebuild/mat/coastal_a_zones.pdf for details.

Other ConsiderationsAs previously stated, in addition to reduced building damage, there are other reasons to design for flood levels above the BFE: Reduced building maintenance After Roof Collapse and longer building life Reduced flood insurance premiums Reduced displacement and dislocation of building occupants after floods (and need for temporary shelter and assistance)  

Reduced job loss Increased retention of tax baseUntil flooded, many homeowners and communities don't think about these benefits. However, After Roof Collapse one of the most persuasive (to homeowners) arguments for elevating homes above the BFE is the reduction in annual flood insurance premiums. 

In most cases, flood premiums can be cut in half by elevating a home 2 feet above the BFE, saving several hundred dollars per year in A Zones, and $2,000 or more per year in V Zones. In V Zones, After Roof Collapse savings continue to increase with added freeboard.[Begin table]Flood Insurance Premium Reductions Can Be Significant Example 

1: V Zone building, supported on piles After Roof Collapse or piers, no below-BFE enclosure or obstruction. $250,000 building coverage, $100,000 contents coverage. Floor Elevation above BFE: 1 foot Reduction in Annual Flood Premium: 25%Floor Elevation above BFE: 2 feet Reduction in Annual Flood Premium: 50% Floor Elevation above BFE: 3 feet Reduction in Annual Flood Premium: 

Floor Elevation above BFE: 4 feet Reduction in Annual Flood Premium: 67% Example 2: A Zone building, slab or crawlspace foundation (no basement). $200,000 building After Roof Collapse coverage, $75,000 contents coverage.Floor Elevation above BFE: 1 foot Reduction in Annual Flood Premium: 39%Floor Elevation above BFE: 

2 feet Reduction in Annual Flood Premium: 48% Floor Elevation above BFE: 3 feet Reduction in Annual Flood Premium: 48%Floor Elevation above BFE: 4 feet Reduction in Annual Flood Premium: 48% Compared After Roof Collapse to flood premium with lowest floor at BFE 

The Average Cost For Mold Removal

Mold has become a major source of concern related to health in the indoor environment. Molds are an important part of the natural environment and have been around for a long time. They are classified as part of the kingdom fungi being neither plant nor animal but a little of both and their role is t  read more..

How To Clean Mold

Fungi and Bacteria in Ventilation Systems Fungi growing in ventilation systems may contaminate indoor environments and cause a variety of problems. Some fungi can cause lung infections. Many fungi can cause allergic reactions in susceptible people and respiratory irritation in non-allergic people.In  read more..

Asbestos Shingles

What Should Be Done About asbestos In The Home? If you think asbestos may be in your home, don't panic! Usually the best thing is to LEAVE asbestos material that is in good condition ALONE. Generally, Asbestos Abatement Asbestos Shingles material in good condition will not release asbestos fibers. 

  read more..

Radon Maps

Biological Air Pollutants Provide adequate outdoor air ventilation. Keep equipment water reservoirs clean. Eliminate standing water, wash bedding and soft toys frequently in hot water. Vacuum carpets and upholstered furniture regularly. Read more at www.epa.gov/iaq/biologic.html Volatile O  read more..

Soot

Top of Form RICHLAND, Wash. – Cutting the amount of short-lived, climate-warming emissions such as Fire Damage Soot and methane in our skies won't limit global warming as much as previous studies have suggested, a new analysis shows.

The study also found a comprehensive climate policy (includin  read more..

Water Damage

When dealing with larger Document restoration Water Damage projects additional control measures should be applied for sensitive areas such as patient care, office settings or vivarium areas.  The application of these measures should be made on a case-by-case basis, such as enclose and close off critical areas with p  read more..

Crawlspace Drying

When Sewage Cleanup Crawlspace Drying backup in an area has happened, either from inside causes, like heavy rains or sewer clogged, important measures should be taken to make sure the health and safety of people involved. If the homeowner is not able to accomplish the sewage cleanup process in a short amount of tim  read more..

How To Disinfect Sewer Spillage

Sewer Backup and Stoppage Policy City personnel will check for and clear any debris creating a sewer blockage that are located in a main sewer line.City personnel will check any service lateral for blockages provided the property owner locates and Sewage Cleanup How To Disinfect Sewer Spillage provides access to a clean-out plug l  read more..

Lead Paint Testing For Paint Contractors

Educate small painting and remodeling contractors about lead-safe work practices to protect the health of occupants (especially small children) and employees. From 1996 to 2000, 34 half-day lead awareness trainings were held throughout California to increase contractors' use Lead Paint Removal Lead Paint Testing For Paint Contractors of lead-s  read more..

Toxic Mold Decontamination Remediation

Concern about indoor exposure to mold has been increasing as the public becomes aware that exposure to mold can cause a variety of health effects and symptoms, including allergic reactions. This document presents guidelines for the remediation/cleanup of mold and moisture problems in schools and com  read more..