Radon Mitigation >> Radon Gas Measurement Methods

AC - Activated Charcoal Adsorption For this method, an airtight container with activated charcoal is opened in the area to be sampled and radon in the air adsorbs onto the charcoal granules. At the end of the sampling period, the container is sealed and may be sent to a laboratory for analysis.The gamma decay from the radon adsorbed to the charcoal is counted on a scintillation detector and a calculation based on calibration information is used to calculate the radon concentration at the Radon Gas Measurement Methods sample site.

Charcoal adsorption detectors, depending on design, are deployed from 2 to 7 days. Because charcoal allows continual adsorption and desorption of radon, Radon Gas Measurement Methods the method does not give a true integrated measurement over the exposure time. Use of a diffusion barrier over the charcoal reduces the effects of drafts and high humidity. 

All applicants and participants in the Program are responsible for developing their own calibration curves. Use of curves developed by EPA for its own charcoal canister (AC) Programs is not appropriate; Radon Gas Measurement Methods do not use the information contained in EERF Standard Operating Procedures for Rn-222 Measurement Using Charcoal Canisters (EPA 520/5-87-05, as amended, October 1989). 

AT - Alpha Track Detection (filtered)For this method, Radon Gas Measurement Methods the detector is a small piece of special plastic or film inside a small container. Air being tested diffuses through a filter covering a hole in the container. When alpha particles from radon and its decay products strike the detector, they cause damage tracks. 

At the end of the test the container is sealed and returned to a laboratory for reading.The plastic Radon Gas Measurement Methods or film detector is treated to enhance the damage tracks and then the tracks over a predetermined area are counted using a microscope or optical reader. The number of tracks per area counted is used to calculate the radon concentration of the site tested. 

Exposure of alpha track detectors is usually 3 to 12 months, but because they are true integrating devices, Radon Gas Measurement Methods alpha track detectors may be exposed for shorter lengths of time when they are measuring higher radon concentrations. UT - Unfiltered Track Detection The unfiltered alpha track detector operates on the same principle as the alpha track detector, except that there is no filter present to remove radon decay products and other alpha particle emitters. 

Without a filter, the concentration of radon decay products decaying within the "striking range" of the detector depends on the equilibrium ratio of radon decay products to radon present in the area being tested, Radon Gas Measurement Methods not simply the concentration of radon. Unfiltered detectors that use cellulose nitrate film exhibit an energy dependency that causes radon decay products that plate out on the detector not to be recorded.

This phenomenon lessens, but does not totally compensate for the dependency of the calibration factor on equilibrium ratio. For this reason, Radon Gas Measurement Methods EPA currently recommends that these devices not be used when the equilibrium fraction is less than 0.35 or greater than 0.60 without adjusting the calibration factor. EPA is currently evaluating this device further to determine more precisely the effects of equilibrium fraction and other factors on performance. 

These evaluations will lead to a determination as to whether to finalize the current protocol or Radon Gas Measurement Methods remove the method from the list of Program method categories.4. LS - Charcoal Liquid Scintillation This method employs a small vial containing activated charcoal for sampling the radon. After an exposure period of 2 to 7 days (depending on design) the vial is sealed and returned to a laboratory for analysis. 

While the adsorption of radon onto the charcoal is the same as for the AC method, analysis is accomplished by treating the charcoal with a scintillation fluid, Radon Gas Measurement Methods then analyzing the fluid using a scintillation counter. The radon concentration of the sample site is determined by converting from counts per minute.

CR - Continuous Radon Monitoring This method category includes those devices that record real-time continuous measurements of radon gas. Air is either pumped or diffuses into a counting chamber. The counting chamber is typically a scintillation cell or ionization chamber. Scintillation counts are processed by electronics, Radon Gas Measurement Methods and radon concentrations for predetermined intervals are stored in the instrument's memory or transmitted directly to a printer.

EL - Electret Ion Chamber: Long-Term For this method, an electrostatically charged disk detector (electret) is situated within a small container(ion chamber). During the measurement period, radon diffuses through a filter-covered opening in the chamber, Radon Gas Measurement Methods where the ionization resulting from the decay of radon and its progeny reduces the voltage on the electret. A calibration factor relates the measured drop in voltage to the radon concentration. 

Variations in electret design determine whether detectors are appropriate for making long-term or short-term measurements. EL detectors may be deployed for 1 to 12 months. Since the electret-ion chambers are true integrating detectors, Radon Gas Measurement Methods the EL type can be exposed at shorter intervals if radon levels are sufficiently high. 

ES - Electret Ion Chamber: Short-Term For this method, an electrostatically charged disk detector (electret) is situated within a small container(ion chamber). During the measurement period, radon diffuses through a filter-covered opening in the chamber, Radon Gas Measurement Methods where the ionization resulting from the decay of radon and its progeny reduces the voltage on the electret. 

A calibration factor relates the measured drop in voltage to the radon concentration. Variations in electret design determine whether detectors are appropriate for making long-term or short-term measurements. ES detectors may be deployed for 2 to 7 days. Since electret-ion chambers are true integrating detectors, Radon Gas Measurement Methods the ES type can be exposed at longer intervals if radon levels are sufficiently low.

GC - Grab Radon/Activated Charcoal This method requires a skilled technician to sample radon by using a pump or a fan to draw air through a cartridge filled with activated charcoal. Depending on the cartridge design and airflow, Radon Gas Measurement Methods sampling takes from 15 minutes to 1 hour. After sampling, the cartridge is placed in a sealed container and taken to a laboratory where analysis is approximately the same as for the AC or LS methods.

Cleanup A Trashed Repo

The service of a notice to quit upon a tenant or person in possession does not authorize an action to be maintained against the tenant or person for the possession of the premises until the expiration of the period for which that tenant or person may have paid rent Tenant Move Out Cleanup Cleanup A Trashed Repo for the premises in  read more..

Remove Smoke Odor After A Fire

How can I remove the smell of smoke from my books/documents? The odor from smoke is hard to eliminate, but the following tips may be helpful in removing it from your materials: Carefully wipe books with a soft cosmetic brush to remove any dirt or other particles. Dirt holds the smell to the pages. S  read more..

Meth Manufacturing Labs

Once decontamination is completed, the certified contractor must perform the post-decontaminationsampling to determine compliance with the decontamination standard. It is also the responsibility of thecertified contractor to arrange for disposal of all waste materials, Meth Lab Cleanup Meth Manufacturing Labs inspect the dumpster  read more..

Debris Removal

If you have a good lease you will be able to recoup some of your money. However most people do not have a thorough lease so water damage, and damage from mold, basic neglect are not covered in the lease. If you do have a good lease and the tenant fails to inform you that there is a water leak   read more..

Water Damage Carpet Cleaning Hints

There is a lot of misinformation circulating on social networks regarding the response and recovery effort for Hurricane Sandy. Rumors spread fast: please tell a friend, share this page and help us provide accurate information about the types of assistance available.Check here often for an on-going   read more..

Who Cleans Apartments That Have Been Trashed

Occupancy under a rental agreement covering premises used as part of a transitional or supportive housing program that is sponsored or operated by a public corporation or by a nonprofit corporation and that provides shelter and related support services intended to improve the occupant's opportunity   read more..

Exterior Lead Based Paint Removal

How often should my blood lead level be checked? Blood lead level (BLL) describes the amount of lead in the blood, measured in micrograms per deciliter (µg/dL).The typical BLL for U.S. adults is less than 10 µg/dL. The New York State Department of Health recommends that:An initial blood lead t  read more..

Chrysotile

Abstract This review provides a basis for substantiating both kinetically and pathologically the differences between chrysotile and amphibole asbestos. 
Chrysotile, which is rapidly attacked by the acid environment of the macrophage, falls apart in the lung into short fibers and particles  read more..

Frozen Pipe Burst Prevention

Cold Weather TipsGuard Against Cold DraftsSince most water meters and pipes are located in unheated areas, they are vulnerable when temperatures dip below freezing. Even a small draft of cold air through a cracked basement window, Water Damage Frozen Pipe Burst Prevention foundation or sill during extremely cold periods could  read more..

Water Heater Leaking From The Bottom

After floods, excess moisture and standing water contribute to the growth of mold in homes and other buildings. When returning to a home that has been flooded, be aware that mold may be present and may be a health risk for your family. People at Greatest Risk from Mold People with asthma, allergies   read more..