Lead Paint Removal >> Dust From Removing Lead Paint

Get Ahead of Lead! Encapsulants: A Teachnique to Control Lead Paint Hazards A complete copy of the Get Ahead of Lead! Encapsulants: A Technique to Control Lead Paint Hazards brochure is available in Adobe Portable Document Format (PDF, 175 KB). Lead-based paint is a health hazard to children and adults because the dust chips and Dust From Removing Lead Paint fumes can be ingested or inhaled. 

In 1978, the U.S. Consumer Product Safety Commission limited the amount of lead allowed in paint. Any surface painted before that year has the potential to be a lead hazard.Lead paint hazards can be controlled in several ways: Doors and windows containing lead paint can be replaced, Dust From Removing Lead Paint paint can be removed utilizing a method that minimizes dust and fumes, or surfaces can be covered with hard materials, such as sheet rock or paneling.

The use of encapsulants is also available as a technique to prevent exposure to lead-based paint. The instructions and guidance of the manufacturers must be followed to test, prepare and apply these products.What are encapsulants? Encapsulants are materials that are applied over lead-based paint to seal the paint to a surface and Dust From Removing Lead Paint prevent the release of paint chips or dust. 

The material may be either a liquid or Dust From Removing Lead Paint an adhesive. Encapsulation provides a barrier between the paint and the environment. Conventional paint is NOT an encapsulant. How do encapsulants work? Encapsulants cover lead paint so that the paint cannot produce dangerous dust, and humans cannot come into contact with it. 

Encapsulants work best on clean, dry and solid surfaces. Encapsulants cannot be used on the following:Surfaces that are walked on; Dust From Removing Lead Paint Surfaces that rub together; Surfaces that are badly deteriorated.Are encapsulants all the same? There are three types of encapsulants: There are polymers (chemical compounds) that form a flexible, resilient membrane. 

They are applied with a brush, roller, or airless spray gun.There are epoxy or polyurethane polymers that form a membrane with a hard, Dust From Removing Lead Paint but flexible, surface. They are applied with a brush, roller, or airless spray gun.There are cement-like materials with polymers that cure to form a thick coating. They are generally applied with a trowel.

How do I decide to use an encapsulant? There are several points to consider before using an encapsulant: You must follow the manufacturer's Dust From Removing Lead Paint guidelines for testing, preparation and application. The person performing the on-site testing to determine appropriate surfaces for encapsulants must meet standards set by the manufacturer.

Although encapsulants offer permanent protection from lead-based paint, they must be periodically inspected and repaired, if damaged.You must use different encapsulants in different situations. Follow the manufacturers' recommendations and instructions. Encapsulation, Dust From Removing Lead Paint or any other measures used to control conditions related to lead poisoning, must have prior approval by the state or local department of health.

When covering lead paint, some thicker encapsulants may also destroy architectural detail, especially on moldings. Encapsulants must be applied by a person who has met the manufacturers' specifications. Contact the manufacturer for specific criteria. The only permanent solutions that do not require periodic maintenance and inspection include replacement of doors and windows, or Dust From Removing Lead Paint complete removal of lead paint.

How do I find out which encapsulants are acceptable for use in New York State? Call your local health department or the state Department of Health's Housing Hygiene Unit at 518-402-7600.The state Health Department issues an "Acceptable Encapsulant Product List." Consult the Dust From Removing Lead Paint list for encapsulant product names. 

Products on this list meet the safety and performance standards of the American Society for Testing and Materials Standard.What surfaces are suitable for encapsulation?The suitable surfaces should have the following characteristics: Dry and Dust From Removing Lead Paint free of grime, dirt, dust, grease, charring, smoke residue (especially cigarette or hydrocarbon), mildew, or other contaminants. 

Water-based encapsulants will tolerate damp, but not wet, surfaces without losing their most important properties.Free of water leaks.Non-glossy. High-gloss surfaces can be deglossed with chemical deglossers or Dust From Removing Lead Paint wet sanding before encapsulation.In architecturally sound condition.Undamaged (i.e., no holes or large cracks in walls). 

Damaged areas must be repaired prior to encapsulation.What surfaces are not suitable for encapsulation? "Friction" and high profile (i.e., protruding window sills) surfaces are not suitable, Dust From Removing Lead Paint regardless of their condition. Friction surfaces include window jambs; glides; headers; some stops and parting beads; inside, close-fitting door jambs and stops; floors; stair treads; and thresholds. 

Cabinets with friction surfaces, such as drawers and cabinet doors, should be examined before encapsulation. Where friction exists, planing or Dust From Removing Lead Paint smoothing of the surfaces is recommended.What are the advantages of using encapsulants? Residents may not need to leave the building during surface preparation and application if dust is not released. 

Occupants should never be in the immediate work area (i.e., same room) during application.If a surface with lead paint is intact, it may be possible to apply an encapsulant without surface preparation.Use of encapsulants may be less costly, Dust From Removing Lead Paint more time saving and safer than other methods.What are the disadvantages of using encapsulants?

There is limited experience or Dust From Removing Lead Paint information on long-term performance of encapsulants. Encapsulants cannot be used on surfaces that experience abrasion or constant friction. Encapsulants may prematurely wear on a surface that experiences repeated impact, such as door stops, window stops and stair treads.

Encapsulants may peel off improperly prepared surfaces that have old undercoats of paint. Encapsulants must be tested on-site before application. Encapsulants require periodic inspection for repair or Dust From Removing Lead Paint maintenance. Water from roof leaks or broken pipes may damage encapsulants. Encapsulants must be applied when the air temperature and relative humidity are within specified ranges. 

Lead is a metal found naturally occurring in the earth. It had been used for centuries in many products and Dust From Removing Lead Paint materials before its effects were known. Its use in paint, plumbing, and gasoline has contributed to widespread public health concern. Why is lead exposure a health concern? Lead acts as a poison if it enters the human body. 

Once lead gets into the body, it can stay there for a long time. It is stored in three places: the blood, organs and bones. Lead stays in the blood for about a month, in organs for several months, but it can remain in the bones for years. It affects the brain and nervous system, reproductive capabilities, Dust From Removing Lead Paint the kidneys, the digestive system and the body's ability to make blood.

Black Mold Exposure

Although the largest group of patients had diffuse pulmonary infiltrates, a significant fraction had focal pulmonary disease, meningitis, Mold Remediation Black Mold Exposure or other extrapulmonary disease. Six patients had only a positive serologic test with no other evidence of infection. Excluding the patients who ha  read more..

Tree Damage Cleanup Hints From Wind

The winds that blew throughout the state Wednesday night brought down approximately 300-400 trees in the Mammoth Lakes Basin. Most of the trees were located in the vicinity of the Mammoth Lakes Pack Station. Many of the uprooted trees have not completely fallen to the ground, but rather are leaning   read more..

Chrysotile

Abstract This review provides a basis for substantiating both kinetically and pathologically the differences between chrysotile and amphibole asbestos. 
Chrysotile, which is rapidly attacked by the acid environment of the macrophage, falls apart in the lung into short fibers and particles  read more..

Asbestos Testing

Asbestos might still be located in many different structural materials and products, in spite of their age. Consequently, the only way to ultimately know is to have samples of the material in question analyzed. Check your local health office for reports on sampling and testing for more   read more..

Lead Paint Removal And Disposal

How Are Workers Exposed to Lead?Workers can be exposed to lead by creating dust or fumes during everyday work activities. Fumes are easier to breathe in and therefore maybe more dangerous than dust. These are some of the most common ways to be exposed.LEAD DUST is produced in many ways including: Gr  read more..

Secure Your Roof Against Hurricane Winds

During a hurricane, homes may be damaged or destroyed by high winds and high waves. Debris can break windows and doors, allowing high winds inside the home. In extreme storms, such as Hurricane Andrew, Wind Damage Secure Your Roof Against Hurricane Winds the force of the wind alone can cause weak places in your home to fail.    read more..

Mold Remediation

A constant presence of humidity in no time will start to form mold, and because in most cases mold will reproduce by forming spores that are released into the air. As the mold spores land on a moist, damp surface they will begin to multiply. Mold will penetrate right through porous materials   read more..

Get Rid Of Mold And Mildew In The Crawl Space Under A Mobile Home

Most building codes require crawlspace vents to aid in removing moisture from the crawlspace. However, many building professionals are now recognizing that an unvented crawlspace (or closing crawlspace vents after the crawlspace has had time to dry out after construction) is the best option in homes  read more..

Reading A Radon Detector

In order to become or remain listed, new applicants and existing participants must meet a number of programmatic requirements. Participation in the Program is voluntary; there is no Federal requirement that radon service providers participate. However, Radon Mitigation Reading A Radon Detector some state and local governments  read more..

Tree Removal From Thunderstorms

The Inyo National Forest, Mammoth Ranger District is soliciting comments on a proposed project to remove wind-fallen trees from Reds Meadow Valley. On November 30 of last year an extreme wind event caused large numbers of trees to be blown down Wind Damage Tree Removal From Thunderstorms in the Reds Meadow Valley. 
<  read more..