Meth Lab Cleanup >> Physical Symptoms Of A Meth Lab In Your Apartment

CLEANUP PROCEDURES FOR SOIL, GROUNDWATER AND SURFACEWATER
If areas of soil, surface water or groundwater contamination Physical Symptoms Of A Meth Lab In Your Apartment are present, characterizationand cleanup of these areas should be conducted by a professional environmentalcontractor, in consultation with the CT Department of Environmental Protection,Emergency Response Division (866-DEP-SPILL). 12IV. REFERENCESADEC 2004.
 
Guidance and Standards for Cleanup of Illegal Drug-Manufacturing Sites.Alaska Department of Environmental Conservation, Physical Symptoms Of A Meth Lab In Your Apartment Spill Prevention and ResponseDivision, Prevention and Emergency Response Program, November 2004.CDPHE 2003. Cleanup of Clandestine Methamphetamine Labs Guidance Document.Colorado Department of Public Health and Environment, July 2003.MDH 2003. Clandestine Drug Labs General Cleanup Guidelines. Minnesota Departmentof Health, September 2003.WSDH 2004.
 
Guidelines for Sampling of Illegal Drug Manufacturing Sites. WashingtonState Department of Health, January 2004. 13APPENDIX ASUMMARY OF THREE COOKING METHODS(ADEC 2004)1) Red phosphorus-Substances commonly associated with this method include:hydrochloric acid methanolhydriotic acid Physical Symptoms Of A Meth Lab In Your Apartment hydrogen peroxidesulfuric acid naphtha (Coleman fuel)sodium hydroxide (lye) acetonesodium chloride (salt) benzenered phosphorus tolueneiodine ethyl ether (starter fluid)isopropyl alcohol freonethyl alcoholhydrogen chloride gaschloroformcharcoal lighter fluid (mineral spirits, petroleum distillate)
 
Also included may be: acetic acidMethyl-ethyl-ketone (MEK)Hypophosphorus acidWaste generated may include:Potentially flammable extraction process sludgesPhosphine gasHydriotic acid Hydrogen Physical Symptoms Of A Meth Lab In Your Apartment Chloride GasPhosphoric AcidWhite or Yellow Phosphorus2) Birch MethodAlso called the "Ammonia” or "Nazi” method. The method relies on a plentifulsupply of anhydrous ammonia that is most commonly found in commercialfreezers and agricultural applications.
 
Substances associated with this method include:Anhydrous ammonia FreonLithium metal Ethyl etherSodium metal Chloroform Physical Symptoms Of A Meth Lab In Your Apartment Isopropyl alcohol Methyl-ethyl-ketone (MEK)EthanolMethanolHydrogen chloride gas 14Hydrochloric acidSulfuric acidSodium chlorideTolueneNaphthaWastes generated include:Potentially flammable extraction process sludgeHydrogen Chloride Gas3) Amalgam or P2P MethodsThis method uses phenyl-2-propanone (P2P) and methylamine as precursors. Other substances used are mercuric chloride, lead acetate, and many other substances.
 
 However, this method is much less common and has not been seen inmany states. 15APPENDIX BCOLLECTION OF NON-POROUS SURFACE SAMPLES (WIPE SAMPLES)(WSDH 2004)To determine the extent of contamination on non-porous surfaces (tile, linoleum andFormica), a technique known as "wipe” sampling is used. On porous areas, such as carpetor drapes, this sampling technique is only Physical Symptoms Of A Meth Lab In Your Apartment satisfactory for a qualitative (absence orpresence) identification of the chemical.Paper filters are generally used for collection of metals.
 
Mixed cellulose ester filter discs(AA filters) or smear tabs, or their equivalent, are most often recommended. Polyvinylchloride filters are available for substances that are unstable on paper-type filters. Physical Symptoms Of A Meth Lab In Your Apartment Squaresof a gauze material may be used for many organic substances, and have the advantage ofbeing more durable than filter media, especially when wiping rough surfaces. They maybe used dry, or wetted with water or solvent to enhance collection efficiency.
 
The following procedure is recommended for collecting wipe samples:
1. If multiple samples are to be taken at the worksite, prepare a rough sketch of the areato be wipe sampled.
2. A new set of clean, impervious gloves should be used for each sample to avoidcontamination of the filter by previous samples (and the possibility of false positives) andto prevent contact with the substance.
3. Withdraw the filter from the vial with your fingers or clean tweezers. If a damp wipesample is desired, moisten the filter with distilled water (lead samples) or other solvent(methanol for methamphetamine samples) as recommended.
4. Depending on the purpose of the sample, it may be useful to determine theconcentration of contamination (e.g., in micrograms of agent per area). For thesesamples, it is necessary to record the area of the Physical Symptoms Of A Meth Lab In Your Apartment surface wiped (e.g., 1 ft2). This wouldnormally not be necessary for samples taken to simply show the presence of the contaminant.
 
5. Firm pressure should be applied when wiping
.6. Start at the outside edge and progress toward the center of the surface area by wipingin concentric squares of decreasing size.
7. Without allowing the filter to come into contact with any other surface, fold the filterwith the exposed side in. If possible, use the same Physical Symptoms Of A Meth Lab In Your Apartment filter to repeat the sampling of thesame area, then fold it over again. Place the filter in a sample vial, cap and number it, andnote the number at the sample location on the sketch. Include notes with the sketch givingany further description of the sample.
 
168. At least one blank filter treated in the same fashion, but without wiping, should be
1. submitted for each sampled area. Preloading a group of vials with sampling filters (consult the OSHA Chemical Sampling Information files to determine appropriate sampling media to use) is a convenient Physical Symptoms Of A Meth Lab In Your Apartment method to carry the sample media to the worksite. (Smear tabs should be inserted with the tab end out.) Clean disposable gloves should be worn when handling the filters and smear tabs.
 
The gloves should not be powdered. The following are general recommendations for taking wipe samples. Physical Symptoms Of A Meth Lab In Your Apartment Using the filter, wipe an area about 100 cm2, rubbing the entire area side to side, then up and down. In many cases (such as knobs and levers) it may not be possible to wipe 100 cm2.
 
 2. Place the filter in a sample vial, cap and number it, and note the number at the sample location. Include Physical Symptoms Of A Meth Lab In Your Apartment notes which will provide any additional relevant details regarding the nature of the sample (e.g., "Fred Employee's respirator, inside"; "Lunch table").
 3. At least one blank filter treated in the same fashion, but without wiping, should be submitted for each sampled area.
4. Some substances (e.g., benzidine, hexavalent chromium, 4,4'-methylenedianiline) are unstable and may require a solution to be added to the vial as soon as the wipe sample is placed in the vial or may require other special sample handling. If such instability is suspected, check the OSHA Chemical Sampling Information file for sample handling instructions or contact SLTC for guidance.
5. Submit the samples, each sealed with a Form OSHA-21, and in accordance with procedures located in OTM Chapter 4, to the SLTC with a completed Form OSHA-91A.

Odor Control

Say Tenant Move Out Cleanup Odor Control out and did not inform you and it's been a couple of weeks. In that time animals of moved in and started living in your rental. How do you get them out of the walls and attic now that they've taken up residence there. Call a professional restoration company dealing with animal remova  read more..

How To Clean Water Damaged Carpet

Samples of street mud, suspended and bottom sediment in canals discharging to Lake Ponchartrain, and suspended and bottom sediment in the lake were collected and analyzedfor chemical constituents to help evaluate the effects of Hurricanes Katrina and Rita Water Extraction How To Clean Water Damaged Carpet and the subsequent unwatering  read more..

How To Remove Storm Damage Debris In An Emergency

Participating states said that having a debris management plan and prequalified debris contractors facilitated better-organized and managed debris removal operations. FEMA received feedback on the pilot program from regional, state, and local stakeholders, Debris Removal How To Remove Storm Damage Debris In An Emergency who said that the pilot prog  read more..

Mask The Smell Of A Dead Animal Under The House

Step 4. Determine if young are involved After finding the main entry you need to verify that no young are inside before proceeding with the eviction process. Because each situation and each animal is different, do this even if it seems early or late in the year for young to be present. Failing to do  read more..

Wind Structural Design

Wind forces are also hazards to foundations. Wind pressure against the walls of an elevated house produce enormous strain on the superstructure-to-foundation Wind Damage Wind Structural Design connection. 

Further, poorly embedded pile-and-pier foundations are subject to racking (horizo  read more..

Basement Sealing

Basement sealing Insulation A properly insulated Basement Drying Basement Sealing can save you money on heating and provide a dry, comfortable living space. In most cases, a basement sealing with insulation installed on its exterior walls should be considered a conditioned space. 

Even in a hou  read more..

Best Way To Remove Hurricane Damage Debris

FEMA concurs with this recommendation. FEMA encourages PA applicants to use force account labor to conduct their debris removal operations. FEMA currently reimburses PA applicants for force account overtime hours. FEMA also reimburses applicants for the use of Debris Removal Best Way To Remove Hurricane Damage Debris equipment. Current FEMA   read more..

Desiccant Vs Mechanical Dehumidification

System description and operation principle Various low-temperature desalination units have been constructed base on the principle of humidification-dehumidification. The basic principle of all these techniques is to convert salt water to humidified air and Dehumidification Desiccant Vs Mechanical Dehumidification then condense the water vapo  read more..

Mold Problems Cause Asthma

Anyone can have asthma, including infants and adolescents. The tendency to develop asthma is often inherited; in other words, asthma can be more common in certain families. Moreover, certain environmental factors, such as viral infections, may bring the onset of asthma. Other environmental factors,   read more..

How To Stop Hoarding Possessions

Pharmacologically, there is little high-quality evidence for benefit of medications. Saxena recently published an open-label study showing positive effects using serotonin reuptake inhibitors (both selective serotonin reuptake inhibitors and serotonin norepinephrine reuptake inhibitors) in OCD and n  read more..