Electronic Restoration >> Basement Drying

Once you are satisfied that the logic board is cleaned and contacts also are cleaned, you may use the hairdryer on its coldest setting and dry the logic board. You may also want to place the Basement Drying device under a lamp, such as a desk lamp, to gently warm and further dry the cleaning fluid. You can use distilled or deionized water as an alternative cleaning fluid although this will take longer to dry.

  1. Completely submerge the item in this container, this will displace the remaining liquid in your Basement Drying device. Using a toothbrush or other similar small brush with soft bristles, clean the circuit board of any debris or deposits. Use caution as you claim to avoid damaging circuit board or dislodging any of the components on the circuit. Paying special attention to the connectors and the ends of ribbon cables to prevent their corrosion. Reassemble your device with and battery or one that is known to be good. If your device was totally submerged that you will probably need a new battery once you have your Basement Drying device assembled the real work of evaluating the damage began.
  2. Turn the device on and make sure that it functions as it did before it was flooded. Decide the kind of water damage that was sustained, if it was clean water, meaning water that directly released from occurrences like a broken water pipe, tub or sink overflows and wrongly diverted rainwater, or it might have been contaminated water, that's water that has been contaminated with sewage, biological or chemical substances. Decide on the occurrence of further facility dangers like a  damaged or crushed asbestos containing materials, electrical dangers, special laboratory/research dangers, falling gypsum board or ceiling tiles, and slippery sidewalks, and address as needed.
  3. If dangerous materials, that are either radiological, chemical, or biological that are stored or used in the immediate area, contact the electronic engineer or restoration manager before continuing. Make sure all water clean-up personnel are properly trained in Basement Drying and informed of possible dangers before starting any work. Electronic restoration contractors should speak with their own health and safety subdivision before starting any work. Work with the electronic engineer to expedite communication with building residents. Work with electronic technicians to address health and safety concerns. Tips on clean up and with general suggestions, instantly repair the water issue by concentrating on the source of the Basement Drying.
  4. Usual problems could include water leaks, maintenance issues, HVAC system problems, and high relative humidity and condensation issues. Completely examine the area to decide on the extent of water damage. Begin the cleanup and complete within 48 hours. In many instances, on-call campus water restoration services could instantly provide the beginning cleanup. Moving of the water damaged furnishings might be required to access carpeting and flooring surfaces underneath. Make sure heavy plastic sheeting is placed under any of the wet building materials or furnishings that were moved to the non-affected areas.  A commercial grade disinfectant cleaner that is indicated as a bacterial and fungicidal, that is recommended for indoor use might be put on the Basement Drying surfaces.

How To Begin To Declutter A Hoarding Situation

Too much clutter and dirt in your home can cause germs, pests, and contaminants to collect, which can make your family sick. A dirty home can put your family at risk for poisonings and injuries, and can cause health problems like asthma."Keeping a home clean includes controlling the source, creating  read more..

Federal Grants For Residential Flood Protection

Odds are that the area where you live will flood again. Before you spend a great deal of money and Flood Damage Federal Grants For Residential Flood Protection effort repairing and rebuilding, ask yourself this question:Do I really want to be flooded again?If you think that you would be better off in a different location,talk to your local government or   read more..

Removing Lead Pipes

Lead can enter drinking water through corrosion of plumbing materials, especially where the water has high acidity or low mineral content that corrodes pipes and fixtures. Homes built before 1986 are more likely to have lead pipes, fixtures and solder. However, new homes are also at risk: Lead Paint Removal Removing Lead Pipes even   read more..

Lead Poisoning Causes Health Problems

Current Cal/OSHA (California Division of Occupational Safety and Health) and Federal OSHA (Occupational Safety and Health Administration) regulations tie BLL testing requirements to air monitoring. Employers must do initial air monitoring and, if air lead concentrations are above 30 µg/m3 more th  read more..

FEMA Flood Maps

What is a Conditional Letter of Map Revision (CLOMR)? A Conditional Letter of Map Revision (CLOMR) is FEM's formal review and comment on whether a proposed project complies with the minimum NFIP FEMA flood maps management criteria. NFIP maps are based on existing, rather than proposed, Flood Damage FEMA Flood Maps&nbs  read more..

Lead Testing In Soil

Is there lead in the soil outside your home? It may have gotten there from paint on the outside of the building or from industry. Or it may have come from car exhaust from the days when gasoline contained lead. Children can be poisoned if they play in soil that has lead in it or if someone trac  read more..

How To Waterproof Cinder Block Basement Walls

Dry floodproofing means sealing a building to keep floodwaters out. All areas below the flood protection level are made watertight. Walls are coated with plastic or rubberized sheeting or special waterproofing compounds. Openings such as doors, windows, sewer lines, and vents are closed permane  read more..

Should You Install A Dehumidifier In Your Crawl Sp

A building that has been flooded can be a dangerous place. This page will provide you information about cleaning up and making your home safe to live in again. See also Going Back In and Being Safe. Stay Safe while you Work.
Crawl Space Drying Should You Install A Dehumidifier In Your Crawl Sp Wear a hard hat and safety goggles when there is a danger o  read more..

How To Get Ready For A Hurricane

Flash floods can occur within a few minutes or hours of excessive rainfall, a dam or levee failure, or a sudden release of water held by an ice jam. Flash floods often have a dangerous wall of roaring water carrying rocks, mud and other debris. Overland flooding, Emergency Board up How To Get Ready For A Hurricane the most common type   read more..

Mold Damage

You want to take good care of your family. You try to eat healthy foods. You take your children to the doctor for regular checkups. You try your best to protect your family from accidents and illness. You want to live in a safe neighborhood and home. But did you know your home might have hidden dang  read more..