Dehumidification >> Desiccant Vs. Mechanical Dehumidification

System description and operation principle Various low-temperature desalination units have been constructed base on the principle of humidification-dehumidification. The basic principle of all these techniques is to convert salt water to humidified air and Desiccant Vs. Mechanical Dehumidification then condense the water vapor for clean water creation. 

The low-temperature distillation is based on the fact that humidified air at elevated temperatures (60-80 ºC) carries a large amount of water vapor. Water-saturated hot air at 30 ºC and 80 ºC has a water partial pressure of 31.8 mm Hg and 355.1 mm Hg; a large amount of water (~517 g/Kg air) can be condensed as clean water when Desiccant Vs. Mechanical Dehumidification humidified air is cooled from 80 ºC to 30 ºC. 

The difference in water vapor pressure at varied temperatures gives the estimate of water treatment capacity, Desiccant Vs. Mechanical Dehumidification as shown in Figure 2-1. The specific energy consumption of the air-enhanced water distillation includes water heating, evaporation, and mechanical energy for pumping water and blowing air. 

To create 1.0 Kg clean water from produced water, the specific energy requirements for water heating, Desiccant Vs. Mechanical Dehumidification evaporation and the air blower are ~229.9 KJ, 2260 KJ, and 7.9 KJ, respectively [Parekh, et al., 2004]. The large amount of latent heat expected in phase conversion (i.e. water evaporation) is the main cause of the energy intensity of conventional distillation processes. 

One way to lower energy consumption is to reuse the latent heat for water heating and evaporation [Hamieh et al., 2006; Bourouni, et al, 2001]. From the three main parts of this system, Desiccant Vs. Mechanical Dehumidification operation principle would be concluded as: (1) improving external heat equipment for deploying different kind energy at each situation or location.

(2) enhancing energy efficacy of desalination system by increasing humidity efficiency, Desiccant Vs. Mechanical Dehumidification condense capacity or latent heat reuse. 2.2 Objective of study The primary aims of this study are: (1) to conduct experimental studies for the concept of produced water desalination by humidification-dehumidification water distillation process.

To determine the influence of operation parameters on humidification-dehumidification separation performance, (3) to characterize the water production Desiccant Vs. Mechanical Dehumidification and energy efficiency and improve the energy efficacy by using built-in capillary condenser, (4) to investigate the purification application of humidification-dehumidification process in coalbed methane produced water purification. 

Scope of study This research focuses on produced water purification at the wellhead Desiccant Vs. Mechanical Dehumidification and beneficial uses in oil production, i.e., drilling fluid, stimulating fluid, and water flooding. Experiments have been carried out to evaluate the humidification-dehumidification process for produced water desalination. 

First, sequences of desalination test on NaCl solutions were tested for optimization of operating parameters, such as air/water ratio, feed water temperature, and air/water flow rate. Then, Desiccant Vs. Mechanical Dehumidification technologies for enhancing energy efficiency were investigated. Measures undertaken for enhancement in latent heat recovery and energy efficiency include.

Built-in water condensers with different configurations for enhancement of latent heat recovery, Desiccant Vs. Mechanical Dehumidification (2) optimizing process for enhancement of heat/mass transfer, and (3) deployment of renewable energies, including solar energy and coproduced geothermal energy, for driving the water desalination process. 

Finally, produced water desalination by humidification-dehumidification process has been tested. Separation performance including ion removal efficiency Desiccant Vs. Mechanical Dehumidification and impact on organic removal were studied. The produced water humidification-dehumidification purification system consisted of a water heating and delivery system, an evaporation and condensation chamber, and the clean water collection and concentrate water recycle system. 

Both the feed and clean water were collected in a time period and stored at 5 ºC for chemistry analysis. Figure 3-1 shows a schematic diagram of this system. The water heating Desiccant Vs. Mechanical Dehumidification and delivery system includes a cole-parmer temperature bath and a Masterflex pump. Feed water was heated to 60 ºC, 70 ºC or 80 ºC in a water bath. 

When temperature reached a preset value, produced water was introduced into the top of humidification-dehumidification chamber by a Masterflex pump at a fixed flow rate. The feed water drained down through a water distributer to form thin water film. Meanwhile, Desiccant Vs. Mechanical Dehumidification the air supplied by a centrifugal blower moved in a counter direction from the bottom of evaporation chamber to the condensation chamber and further contacted with the water film. 

Humidified air formed during the counter movement of air and water film. The humidified air kept flowing into the condensation chamber and formed condensate upon cooling Desiccant Vs. Mechanical Dehumidification and capillary condensation. Condensate purified water exited from the bottom of humidification-dehumidification chamber to a clean water collection bottle. 

At the same time, Desiccant Vs. Mechanical Dehumidification the concentrated wastewater was circulated through a pipe to the produced water tank. Distilled water was added manually into the feed water to maintain a constant ion concentration during the whole experimental process. Both the feed water and purified clean water were collected every two hours for chemistry analysis. 

The produced water humidification-dehumidification system has the similar structure described by Xiong and coworkers [Xiong, et, al. 2005]. The humidification and dehumidification chambers were constructed by plastic shell and 124 copper tubes. Because of two different humidification-dehumidification column design, Desiccant Vs. Mechanical Dehumidification this produced water desalination experiments were carried out by using two different humidification-dehumidification media. 

The first separation column was built by plastic shell column Desiccant Vs. Mechanical Dehumidification and copper pipes as humidifier and heat exchanger. Figure 3-2 gives the schematic diagram of the copper tubing separation column. Copper tubes with outside diameter of 6.35 mm and length of 1.8 m were bundled and embedded into a plastic column. 

Produced water was directed through a water distributer which was made by 124 microbore tubes with inner diameter of 0.25 mm. On the bottom of the column, there are dry air inlet, Desiccant Vs. Mechanical Dehumidification clean water outlet and concentrated water outlet pipes which connected with produced water tank for feed water circulation. 

Produced water was directed through the water distributer to inner surface of the copper tubes Desiccant Vs. Mechanical Dehumidification and contact with upflowing dry air which was blown from the bottom of the column. Humidified air will be generated during the counter movement of falling water film and up-flowing air streaminside the copper tubes. 

Humidified air stream flow to the condensation chamber and clean water start to condense at the outside walls of the copper tube because of temperature difference between inside and outside wall of the copper tubing. As the condensate is generated, Desiccant Vs. Mechanical Dehumidification large quantity of latent heat will be released and will transport to the inside wall surface of the copper pipes. .

Natural Disaster Damage

You could also collect some rainwater and Flood Damage Natural Disaster Damage from streams, rivers, ponds, lakes, and natural springs. But you must be sure you boil any water you plan to drink or use for cooking. Do not drink any floodwater, which is very likely to be contaminated; water from water beds, which has pesticide  read more..

How To Report A Neighbor Who Is A Hoarder In A Con

These documents will establish policy, practices and procedures are intended to reduce and prevent the incidence of severe hoarding among our County residents. These policies, practices and procedures may be either internal to one in nature and appropriate for various departmen  read more..

Debris Removal From The Colorado Floods

2013 Floods  Guidance: Landfill Management of Flood Debris Air Pollution Control Division / Stationary Sources Program The Department will exercise enforcement discretion for landfills which exceed their permitted waste acceptance limit as a result of flood debris disposal. This relief is speci  read more..

Structural Drying

As the materials begin to dry, the small amounts of heat or dehumidification can be introduced to the building. Use of mechanical means will require some caution, none of these mechanical devices should be used when Flood Damage Structural Drying makes their operation dangerous. Ventilation will remain the primary mean  read more..

How To Remove Soot Smoke Smell

Standard on Protective Ensembles for Technical Rescue Operations,2007 Edition The NFPA 1951, 2007 Edition contains performance requirements for a CBRN Technical Rescue Protective Ensemble for use during entry into CBRN atmospheres not Immediately Dangerous to Life of Health (IDLH). 
This   read more..

Classifications Of Smoke Damage

The maximum optical density, Dm, is used primarily in ranking the relative smoke production of a material and in identifying likely sources of severe smoke production. Concerns with the test include the relatively low heat flux exposure, vertical sample mounting, and Smoke Damage Classifications Of Smoke Damage oxygen supply wit  read more..

Blue Water Carpet Cleaning

This is our decision regarding the Application for Further Review of Protest No. 2704-08-100508, timelyfiled on behalf of Rug Doctor, LP ("Rug Doctor"), concerning the classification of carpet cleaning machines Water Extraction Blue Water Carpet Cleaning under the Harmonized Tariff Schedule of the United States ("HTSUS").   read more..

How To Know If You Are A Hoarder

In non-emergency situations, the Mental Health Clinician conducts preliminary outreach via home visit or telephone in hopes of establishing rapport at the outset of the process, i.e. the carrot. Thus far, hoarders have been more amenable to establishing initial communication with a clinical responde  read more..

How To Dehumidify A Bathroom Without Losing Heat

Fans shall be Class II (minimum) construction with single inlet, aluminum wheel and stamped air-foil aluminum blades. The fan wheel shall be mounted on the directly-driven motor shaft in AMCA Arrangement 4. G. Filter Section: Pleated, Dehumidification How To Dehumidify A Bathroom Without Losing Heat disposable pre-filters in outdoor-air inlets suppl  read more..

How To Restore Flood Damaged Pictures

At present, there are limited options available to custodians of documentary resources who wish to extend the life of portions of their collections. If they are dealing with acidic paper, it can be deacidified either item-by-item or Document restoration How To Restore Flood Damaged Pictures  y sending it to a vendor of a mass deacidifica  read more..