Dehumidification >> How To Dehumidify Air

Dehumidification Options Tunnel Moisture Load: The cost of dehumidification is directly related to How To Dehumidify Air the moisture the tunnel air will pick up from water sources in the tunnel. To keep the air dry at low cost, it will be essential that water sources are eliminated or kept to a minimum. Areas where tunnel walls show excessive infiltration should be sealed if possible. 

Water should not be allowed to pool or run through open trenches - drainage should be provided in a closed piping system. The 35km tunnel is approx. 6 times the How To Dehumidify Air size of the current Main Ring tunnel. A recent study of dehumidification issues in the Main Ring showed that humidity comes from 3 principle sources besides the ventilation air intake.

These are: 1. Transmission through concrete = 5 lb/hr 2. Trench and sump evaporation = 170 lb/hr 3. Allowance for water spray from leaks = 70 lb/hr which gives a figure for How To Dehumidify Air moisture build-up in the Main Ring of 245 lb/hr. If we multiply this by the factor of 6 increase in tunnel length for the 3 TeV machine we would have over 1000 lb/hr in moisture released to the tunnel air. 

This straight forward scaling does not directly apply, because water spray from leaks should not be an issue as only cryogens are anticipated in the tunnel. However, trench and sump evaporation, if multiplied by a factor of 6, How To Dehumidify Air would result in 1000 lbs/hr release to the air.Because the dolomite is not a good water conductor at a depth of 400 feet, we can be optimistic about controlling water penetration through the tunnel rock, especially if care is taken to seal the bad spots. 

Trench and sump evaporation can be improved by use of enclosed drain lines and sealed sumps. With How To Dehumidify Air these considerations in mind, we would design a basic dehumidification system to handle 200 lbs/hr, with provision for expansion if conditions prove more extreme in reality. Ventilation System Capacity: The ventilation system shown in figure 1 allows for the minimum breathing requirements for tunnel personnel. 

Air is introduced into the tunnel at one of the two access shafts, and released at the other, How To Dehumidify Air the two halves of the ring being fed in parallel.The system shown has a capacity of about 15,000cfm which results in a 100fpm wind (1mph) through the tunnel and a 1”wc differential pressure end to end. This minimal ventilation reduces moisture load from outside air intake to a minimum, however, it also results in a 10 hour air purge time for the tunnel. 

The cost for this scale of system (not including tunnel ducting) would be about $700K1 . It would have the ability to remove 200 lb/hr of tunnel moisture (in addition to outside air moisture) to How To Dehumidify Air keep the tunnel moisture below the dew point at 55F. The ventilation unit will have to be fitted with heating capacity for winter operation. The ventilation system could be increased to allow for additional capacity.For every 1 lb/hr of tunnel moisture, 75cfm of additional air flow would be needed, at a unit cost of about $3.5K (not including tunnel ductwork).

 At a size of 150,000cfm (allowing the tunnel to be purged in 1 hour) the ventilation system would be able to remove 1800 lb/hr of moisture and with economies of How To Dehumidify Air scale would cost about $5M (not including tunnel ductwork). Air velocities in the tunnel would be about 1000fpm (10 mph) and require a differential pressure of 8”wc across the tunnel, which would require special design considerations. 

Auxiliary Dehumidifiers: Auxiliary tunnel dehumidification units could be placed down the tunnel length. At a half mile spacing between units, 44 units would be required.To preclude dead spots in the tunnel air movement, How To Dehumidify Air due to these units simply recirculating on themselves, it would probably be necessary to run the ventilation system concurrently. These units normally range from 10 lb/hr (size 300 unit) to 32 lb/hr (size 1200 unit) moisture removal capacity each. This would total 440 to 1408 lb/hr capacity for 44 units. The unit cost of this type of equipment runs about $2.5K per lb/hr capacity (not including electrical installation and assuming that no ducting is necessary). 

An example of a ventilation unit mounted in a 10 foot tunnel is shown in figure 2. Other Considerations The 3 TeV accelerator adds about 3 watts per meter in heating to the tunnel. This How To Dehumidify Air represents about a 100 kwatt heating load. This would increase the tunnel air temperature by about 20 degrees F at the exhaust point. This actually serves to help the dehumidification system in the following sense:

 In the Winter, the chiller system is turned off and the outside air is heated before injection into the tunnel. The extra heating from the accelerator components helps this How To Dehumidify Air process. An Electron Ring An electron ring will loose energy in the tunnel due to synchrotron radiation at a rate that may be as high as 50 Mwatts. Such a high heating load could not be air cooled, and would have to revert to another cooling medium - presumably water. 

The addition of a large water cooling capability into the tunnel could complicate the dehumidification problem, How To Dehumidify Air because of the potential for leaks. Recall that the Main Ring must allow for as much as a 70 lb/hr load that could come from leaky water systems.

 Conclusions A ventilation system for a 3 TeV ring need not be an excessive cost to the project. A great deal depends on the care taken to seal potential water sources in the tunnel. Based on the experience gained at the Main Ring tunnel, How To Dehumidify Air a system that can handle a 200 lb/hr load could very well be sufficient. However, the 200 lb/hr system should be treated somewhat optimistically as a target. As more data become available, and plans for the electron machine firm up, the dehumidification requirements can be predicted with greater certainty.

What Home Owner Need Know About Lead Paint Removal

What Home Owners Need to Know About Removing Lead-Based Paint The complete What Home Owners Need to Know About Removing Lead-Based Paint brochure is available as an Adobe Portable Document Format (PDF) file (size 159 KB 2pg). NOTE: If work is being done under an order from a government agency, any m  read more..

Water Damage Restoration For Electronics

Second, although self-healing does occur in the conductive polymer due to degradation of the polymer's conductivity at high temperatures, this self-healing mechanism is not thought to be as effective as the self healing mechanism of MnO2-based tantalum capacitors. Decomposition of the conductive pol  read more..

Office Has Flood Damage

Akron, Ohio (July 11, 2013) - On Wednesday afternoon, July 10, the City of Akron experienced 3 to 4 inches of rain in a very short period of time. Flooding occurred causing the closings of roadways and expressways. Along with the roadway flooding, the City received Flood Damage Office Has Flood Damage reports of nearly 2  read more..

Asbestos Abatement Training

The asbestos awareness training that is provided by OSHA is for workers in a number of different industries, including the construction industry to gain knowledge about the risks of Asbestos Abatement Asbestos Abatement Training. The employees working in the manufacturing industry are also at risk for a significant amount of exposure  read more..

Emergency Board Up

Plywood shutters that you create yourself, if placed correctly, could provide a high degree of Wind Damage Emergency Board Up coverage from flying debris during a storm. Plywood shutters could be placed on all kinds of houses. Measure every window and every door that has glass, and add 8 inches to all the height and w  read more..

Protect Your House From Animal Damage

Step 4. Determine if young are involved After finding the main entry you need to verify that no young are inside before proceeding with the eviction process. Because each situation and each animal is different, do this even if it seems early or late in the year for young to be present. Failing to do  read more..

Foundation Repair

When As Well As Why you Should Turn to Crack in Foundation Repair Services Sooner or later, just about all homes will move and also settle. This could result in chips, which frequently need repairing Basement Drying Foundation Repair piers. Several cracks, however, are simply in the cosmetic finish of the foundation repair. The  read more..

Meth Lab Cleanup

Scientists show how Odor Control Meth Lab Cleanup varied during 47 arrangements of density, aeration rate and ecological situations. The data points signify medians of the levels of butanol matched to residency odor. The data points arose from opinions made by an average of 26 individuals within a given 15-mi  read more..

Thunderstorm Damage

The forces of mother nature, the wind, water, earthquake and even the extremes of temperature  could leave behind debris scattered places, contaminated water, spoiled food, displaced wildlife and overall conditions which, if not treated properly, might lead to major health problems. In t  read more..

Hazardous Materials From Clean Up Flood Damage

In all likelihood, hazardous materials will be encountered during the cleanup phase of the flood recovery effort: containers and other vessels that may hold materials that can either pose an immediate risk to cleanup crews if disturbed or might be classified as a hazardous waste for disposal purpose  read more..