Asbestos Abatement >> How To Dispose Of Asbestos Waste In New Jersey

Send the samples to the laboratory with paperwork requesting asbestos analysis. List any known fibrous interferences present during sampling on the paperwork. Also, note the workplace operation(s) sampled. 5.3.2.Secure and handle the samples in such that they will not rattle during How To Dispose Of Asbestos Waste In New Jersey shipment nor be exposed to static electricity. 

Do not ship samples in expanded polystyrene peanuts, vermiculite, paper shreds, or excelsior. Tape sample cassettes to sheet bubbles and place in a container that will cushion the How To Dispose Of Asbestos Waste In New Jersey samples in such a manner that they will not rattle. 5.3.3.To avoid the possibility of sample contamination, always ship bulk samples in separate mailing containers. 

Analysis 6.1. Safety Precautions 6.1.1.Acetone is extremely flammable and precautions must be taken not to ignite it. Avoid using large containers or quantities of acetone. Transfer the solvent in a ventilated laboratory hood. Do not use acetone near any open flame. For How To Dispose Of Asbestos Waste In New Jersey generation of acetone vapor, use a spark free heat source. 

Any asbestos spills should be cleaned up immediately to prevent dispersal of fibers. Prudence should be exercised to avoid contamination of laboratory facilities or exposure of How To Dispose Of Asbestos Waste In New Jersey personnel to asbestos. Asbestos spills should be cleaned up with wet methods and/ or a High Efficiency Particulate-Air (HEPA) filtered vacuum. 

Caution: Do not use a How To Dispose Of Asbestos Waste In New Jerseyvacuum without a HEPA filter -- It will disperse fine asbestos fibers in the air. 6.2. Equipment 6.2.1. Phase contrast microscope with binocular or trinocular head. 6.2.2. Widefield or Huygenian 10X eyepieces (Note: The eyepiece containing the graticule must be a focusing eyepiece. 

Use a 40X phase objective with a numerical aperture of 0.65 to 0.75). 6.2.3. Kohler illumination (if possible) with green or blue filter. 6.2.4. Walton-Beckett Graticule, type G-22 with 100 plus or minus 2 um projected diameter. 6.2.5. Mechanical stage. A rotating mechanical How To Dispose Of Asbestos Waste In New Jersey stage is convenient for use with polarized light. 

Phase telescope. 6.2.7. Stage micrometer with 0.01-mm subdivisions. 6.2.8. Phase-shift test slide, mark II (Available from PTR optics Ltd., and also  How To Dispose Of Asbestos Waste In New Jersey McCrone). 6.2.9. Precleaned glass slides, 25 mm X 75 mm. One end can be frosted for convenience in writing sample numbers, etc., or paste-on labels can be used. 6.2.10. 

Cover glass #1 1/2. 6.2.11. Scalpel (#10, curved blade). 6.2.12. Fine tipped forceps. 6.2.13. Aluminum block for clearing filter (see Appendix D and  How To Dispose Of Asbestos Waste In New Jersey Figure 4). 6.2.14. Automatic adjustable pipette, 100- to 500-uL. 6.2.15. Micropipette, 5 uL. 6.3. Reagents 6.3.1. Acetone (HPLC grade). 6.3.2. Triacetin (glycerol triacetate). 

Lacquer or nail polish. 6.4. Standard Preparation A way to prepare standard asbestos samples of known concentration has not been developed. It is possible to prepare replicate How To Dispose Of Asbestos Waste In New Jersey samples of nearly equal concentration. This has been performed through the PAT program. These asbestos samples are distributed by the AIHA to participating laboratories. 

Since only about one-fourth of a 25-mm sample membrane is required for an asbestos count, any PAT sample can serve as a "standard" for replicate counting. 6.5. Sample Mounting Note: See Safety Precautions in How To Dispose Of Asbestos Waste In New Jersey Section 6.1. before proceeding. 

The objective is to produce samples with a smooth (non-grainy) background in a medium with a refractive index of approximately 1.46. The technique below collapses the filter for easier focusing and produces How To Dispose Of Asbestos Waste In New Jersey permanent mounts which are useful for quality control and inter laboratory comparison. An aluminum block or similar device is required for sample preparation. 

Heat the aluminum block to about 70 deg. C. The hot block should not be used on any surface that can be damaged by either the heat or from How To Dispose Of Asbestos Waste In New Jersey exposure to acetone. 6.5.2. Ensure that the glass slides and cover glasses are free of dust and fibers. 6.5.3. Remove the top plug to prevent a vacuum when the cassette is opened. 

Clean the outside of the cassette if necessary. Cut the seal and/or tape on the cassette with a razor blade. Very carefully separate the How To Dispose Of Asbestos Waste In New Jersey base from the extension cowl, leaving the filter and backup pad in the base. 6.5.4. With a rocking motion cut a triangular wedge from the filter using the scalpel. This wedge should be one-sixth to one-fourth of the filter. 

Grasp the filter wedge with the forceps on the perimeter of the filter which was clamped between the cassette pieces. DO NOT TOUCH the filter with your finger. Place the filter on the glass slide How To Dispose Of Asbestos Waste In New Jersey sample side up. Static electricity will usually keep the filter on the slide until it is cleared. 6.5.5. Place the tip of the micropipette containing about 200 uL acetone into the aluminum block. 

Insert the glass slide into the receiving slot in the aluminum block. Inject the acetone into the block with slow, steady pressure on the plunger while How To Dispose Of Asbestos Waste In New Jersey holding the pipette firmly in place. Wait 3 to 5 seconds for the filter to clear, then remove the pipette and slide from the aluminum block. 

Immediately (less than 30 seconds) place 2.5 to 3.5 uL of triacetin on the filter (Note: Waiting longer than 30 seconds will result in increased index of refraction and decreased contrast between the fibers and the How To Dispose Of Asbestos Waste In New Jersey preparation. This may also lead to separation of the cover slip from the slide).  

Lower a cover slip gently onto the filter at a slight angle to reduce the possibility of forming air bubbles. If more than 30 seconds have elapsed between acetone exposure and triacetin How To Dispose Of Asbestos Waste In New Jersey application, glue the edges of the cover slip to the slide with lacquer or nail polish.  

If clearing is slow, warm the slide for 15 min on a hot plate having a surface temperature of about 50 deg. C to hasten clearing. The top of the hot block can be used if the slide is not heated too long. Counting may proceed immediately after clearing and mounting are completed. 6.6. Sample How To Dispose Of Asbestos Waste In New Jersey Analysis 

Completely align the microscope according to the manufacturer's How To Dispose Of Asbestos Waste In New Jersey instructions. Then, align the microscope using the following general alignment routine at the beginning of every counting session and more often if necessary. 6.6.1. Alignment (1) Clean all optical surfaces. Even a small amount of dirt can significantly degrade the image. 

Rough focus the objective on a sample. (3) Close down the field iris so that it is visible in the field of view. Focus the How To Dispose Of Asbestos Waste In New Jersey image of the iris with the condenser focus. Center the image of the iris in the field of view. (4) Install the phase telescope and focus on the  phase rings. Critically center the rings. 

Misalignment of the rings results in astigmatism which will  degrade the image. (5) Place the phase-shift test slide on the microscope stage and focus on the lines. The How To Dispose Of Asbestos Waste In New Jersey analyst must see line set 3 and should see at least parts of 4 and 5 but, not see line set 6 or 6. A microscope/microscopist combination which does not pass this test may not be used.

Tenant Trash Haul Away

Repair items that affect the safety and health of the tenant, the tenant may issue what is known as a 21-30 day notice. The tenant must serve the landlord with a written notice of the breach or action affecting the health and safety of the tenant and Tenant Move Out Cleanup Tenant Trash Haul Away request that the landlord correct   read more..

Lead Paint Abatement And Lead Paint Mitigation In

Lead paint removal, lead paint abatement and lead paint mitigation in New York City Rehabilitation, restoration, and maintenance Lead Paint Removal Lead Paint Abatement And Lead Paint Mitigation In projects frequently address old painted surfaces that require preparation and refinishing. In many cases, old lead-based paint is pre  read more..

Basement Water Damage

The best way to face any Basement Drying Basement Water Damage problem is to first, do the obvious things, you know the things that are easy and least expensive. Then continue in a rational order doing the next least expensive thing with the most positive result. With a basement moisture problem, the best way to start is alw  read more..

Flood Damage

Most of the time when there is a tornado or hurricane, there is a certain amount of Emergency Board up Flood Damage, from a long period of rain before, during and after the epicenter of the storm. In order to make preparations for a long duration of steady wind, rain and flying debris, is a good idea to secure your hom  read more..

Lead Based Paint Removal Requirements

How did the Lead Accreditation & Certification Program begin? California's lead accreditation and certification program began in June, 1994. At that time, new childhood lead poisoning prevention legislation (codified in Health and Safety Code 105250 et seq.) required the California Department of  read more..

How To Get The Smell Of Raw Sewage Out Of The Hous

The purpose of this publication is twofold: 1. It provides homeowners with basic information on the causes of sanitary sewer backups.2. It provides homeowners with general information on solutions that can be implemented to protect their property from sanitary sewer backups. This Sewage Cleanup How To Get The Smell Of Raw Sewage Out Of The Hous publ  read more..

How To Restore Flood Damaged Photos

The first formulation of standards of practice and professional relations by any group of art conservators was produced by the IIC-American Group (now AIC) Committee on Professional Standards and Procedures. Document restoration How To Restore Flood Damaged Photos

Formed at the second regular meeting of the IIC-AG, in  read more..

Wet Carpet From Toilet Overflow

Molds are the most common forms of fungi found on earth. They can grow on almost any material, as long as moisture and oxygen are available. Most molds reproduce through the formation of spores, tiny microscopic cells that are resistant to drying and are released into the air. Airborne spores are [M  read more..

How To Fix Drywall In A Flooded Basement

Good Drainage
For best results the footing drains should "daylight", meaning the pipes that carry the water away from the footing drains should slope away from the house and discharge the water to land Basement Drying How To Fix Drywall In A Flooded Basement surface some distance downhill from the basement. The basement floor shou  read more..

How To Dehumidify Air

Dehumidification Options Tunnel Moisture Load: The cost of dehumidification is directly related to Dehumidification How To Dehumidify Air the moisture the tunnel air will pick up from water sources in the tunnel. To keep the air dry at low cost, it will be essential that water sources are eliminated or kept to a minimum. A  read more..